User manual ROWENTA RH8753

[. . . ] € Do not place the appliance near a heat source (ovens, electric heaters or hot radiators). € Do not expose the batteries to a room temperature above 104ºF (40°C). € Never use your vacuum cleaner without the dust tray and the foam rubber motor protection filter. € Do not use the appliance: - If it fell and shows visible signs of deterioration or functional anomalies. [. . . ] € When the brush becomes uncharged, it stops automatically (the light charge signal continues to flicker in blue for about ten (10) seconds). € Before you can use your vacuum cleaner again, you will need to recharge it for at least ten (10) minutes. 14 * May vary according to model RO_AIR_FORCE_EXTREME_903097_05_V8_903097/05 08/04/13 14:40 Page15 • If the appliance does not turn on after this time, and the light charge signal continues to flicker, it means that the battery is still uncharged. USING THE ELECTRO-BRUSH The electro-brush is a rotating, motorized brush that guarantees maximum cleaning effectiveness by allowing the appliance to suck up dirt and clean in depth. The bristles, located all along the brush, remove threads, hair and fur that might be caught on the surface of rugs and carpets. Please note: If the vacuum head adheres too closely to the surface you are cleaning, change the speed to « Minimum ». ATTENTION: Do not vacuum large fragments of broken objects, as they could block and damage the brush. Do not use the electro-brush on long hair carpets, on animal fur, or on fringes. REMOVING AND CLEANING THE ELECTRO-BRUSH ATTENTION: Always turn off the appliance and unplug it before storing or cleaning. Using the tool provided with the appliance (15), press in the two latches located on each side of the lower side of the Delta head (fig. Remove the electro-brush and its lateral bearing in order to clean them (fig. Finally, using the tool provided with the appliance, close both latches (fig. FOR YOUR SAFETY • Do not touch any rotating parts before you turn off and unplug the vacuum cleaner. ELECTRO-BRUSH MALFUNCTION The electro-brush does not function properly or makes an unusual sound • Either the rotating brush or the axis is blocked: turn off the appliance and clean them. € The brush is worn out: visit an authorized Service Center in order to have the brush changed. € The belt is worn out: if the belt makes noise, it means that it is slipping because it’s worn out. The electro-brush stops while you are vacuuming • The thermal security feature has been activated: Turn off the vacuum cleaner by moving the Stop/Start button to the Stop position (2. Check to see if any solid object is blocking the rotation of the brush. If this is the case, remove the object and clean the electro-brush (fig. The electro-brush moves with difficulty If you find that your vacuum cleaner slides with difficulty along surfaces, progressively reduce the speed until you reach the « Minimum » position (3. If the problem persists, take your appliance to the authorized Rowenta Service Center nearest to your home. See the list of authorized Rowenta Service Centers or contact the Rowenta Consummer Service department. [. . . ] Make sure that nothing is blocking the duct between the separator and the dust tray. € The dust tray opening is blocked: Remove the dust tray, empty it and clean the opening. The vacuum head moves with difficulty Lower the vacuum speed by moving the appropriate switch button. If the problem persists, take your vacuum cleaner to the authorized Rowenta Service Center nearest to your home. [. . . ]