User manual ROWENTA RO4351.11 X-TREM POWER ALLERGY CARE

[. . . ] The rewinder and cord assembly of your vacuum cleaner must be replaced by an Approved Service Centre because special tools are required for carrying out any repair in order to prevent any danger. 3 • Repairs Repairs should only be carried out by specialists using original replacement parts. Description 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Cover Bag full indicator Carrying handle Cover opening Automatic cable rewind pedal Bag compartment Bag holder Suction opening HEPA filter cartridge* ref. [. . . ] € For corners and other areas that are difficult to reach: use the crevice tool*. 2 • Plugging in the electrical power cord and using the vacuum cleaner Fully unroll the cord, plug in your vacuum cleaner and press the On/Off pedal, (fig. Set the power using the vacuum cleaner’s power control, if your model is equipped with a High Control wand (fig. 7) you can also adjust the vacuum power using the 3 position slider* : • Position • Position • Position for fabrics and furniture (fig. *Depending on model: this is either equipment specific to certain models or available as an optional accessory. If your appliance is equipped with the Compact System with folding tubes: • Retract the telescopic tubes (fig. 11) and press the «Push» button to open the tube and fold it. € If your appliance is equipped with CLIP’N’STORE, attach your hose to the accessory clip for easier storage (fig. After use, stop your appliance by pressing on the on/off pedal and unplug it (fig. In the upright position, place the suction unit in the parking position (fig. You can then carry and store your vacuum cleaner in the CARE AND CLEANING IMPORTANT Always turn off and unplug your appliance before maintenance or cleaning. Check that the Hepa* filter cassette is fitted correctly before re-closing the cover. IMPORTANT Never operate the vacuum cleaner without a Hepa filter cartridge. Your appliance is equipped with a Hepa filter cartridge presence safety system for this (the cover will not close if a Hepa filter cartridge has not been installed). 1 • Changing the bag The bag full indicator shows you when the bag is full or saturated. If you notice that your vacuum cleaner is less efficient, select the maximum power and hold the nozzle off the floor. [. . . ] Fit the furniture crevice tool onto the end of the power nozzle or the tube. Telescopic crevice tool To get into corners and places that are hard to reach. Fit the telescopic crevice tool onto the end of the power nozzle or the tube. [. . . ]