User manual ROWENTA STEAM FORCE DW9220D1

[. . . ] • When you place the iron on the iron rest, make sure that the surface on which you place it is stable. • Always unplug your appliance: before filling, or rinsing the water tank, before cleaning it, after each use. • Children must be supervised to ensure that they do not play with the appliance. [. . . ] During the first few uses, a harmless odour and a small amount of smoke may be noticeable. Upon the first use, you may notice small particles coming out of the soleplate. This is parf of manufacturing process and is not harmful to you or your garments. You may accelerate this by using the self cleaning function (fig. 13a - 13b) and shaking the iron gently. WHAT WATER MAY BE USED ? Your iron has been designed to operate using untreated tap water. However, if your water is very hard, you can mix 50% untreated tap water with 50% distilled or demineralised water. IMPORTANT Heat concentrates the elements contained in water during evaporation. The types of water listed below contain organic waste or mineral elements that can cause spitting, brown staining or premature wear of the appliance: water from tumble dryers, scented or softened water, water from refrigerators, batteries or air conditioners, pure distilled or demineralised water or rain water should not be used in your iron. Also do not use boiling, or bottled mineral water. USE 1 • Filling the water tank • Before filling the water tank, unplug the iron fig. 2. • Set the temperature control dial fig. 3 on position (Min. ) • Open the filling inlet fig. 4. Close the filling inlet and return the iron to the horizontal position. • You can plug in your iron fig. 6. 2 • Setting the temperature Your iron is equipped with the Autosteam function, it automatically adjusts the steam amount and the temperature based on the selected fabric for optimum results. For perfect results, an optimum position for each fabric has been pre-defined. You can also set your iron based on the international temperature measurements •, ••, •••. When your iron reaches the required temperature, the thermostat indicator turns off fig. 7. You can start ironing. (*) Depending on model 3 1103909885 DW9220 DW9225 D1_110x220mm 26/02/13 08:57 Page4 FABRIC Nylon (Synthetic fibres, e. g. [. . . ] They will permanently damage your iron. The Self Clean function flushes dirt and scale particles out of the steam chamber. Fill the water tank with untreated tap water up to the max mark and heat the iron to the ••• temperature. Push the self clean button for 1 minute fig. 13a-13b and shake the iron gently: steam will now begin to build up. [. . . ]