User manual RUSSELL HOBBS 11521

[. . . ] Brush it with a soft brush, under a running tap Rinse the kettle, in case any scale particles have fallen inside. To replace, simply slide the filter back down the grooves on either side of the spout. If it's not working, read the instructions, check the plug fuse and main fuse/circuit breaker. [. . . ] You may use a little household detergent, but if you do, rinse well to avoid tainting the water. Don't use harsh or abrasive cleaners or solvents. important safeguards Follow basic safety precautions, including: 1. Don't put the kettle, power base, cable, or plug in any liquid; don't use the kettle in a bathroom, near water, or outdoors. 2. This kettle must only be used by or under the direct supervision of a responsible adult. 5. Take care when pouring -- pour slowly, and don't over-tilt the kettle. Keep the kettle, power base, and cable away from the edges of worktops and out of reach of children. 7. Route the cable so it doesn't overhang and can't be caught accidentally or tripped over. 8. Unplug the power base when not in use, before repositioning and before cleaning. 9. Check the lid is properly closed before switching the kettle on, otherwise it may not switch off. 10. Check the kettle is properly located on the power base before switching on. 11. Don't switch on unless the kettle contains at least 2 cups of water. 14. Keep the kettle, power base, cable, and plug away from sources of heat. 15. Don't use the kettle for any purpose other than heating water. If the power base or cable is damaged, replace the power base, in order to avoid hazard. filling warning Keep clear, steam will escape from the lid. Switch the kettle off -- press the switch down (O). Check it's closed, or the kettle won't switch off when it boils. scale switching on Switch the kettle off -- press the switch down (O). Gently position the kettle on the power base -- take care not to spill. The light will come on, and the kettle will heat up. Scale deposits may be white, coloured, or even rusty. They overheat the element, reduce its working life, and make the boil-dry cut-out operate prematurely. As the element is mounted under the kettle, there are no nooks and crannies to give the scale a foothold. [. . . ] Follow the instructions on the descaler, rinse several times, then fill, boil and discard the water, to ensure no residues are left. nb Products returned under guarantee with faults due to scale will be subject to a repair charge. filter guides spout lid handle release connector contact max water level indicator household use only before using for the first time insufficient water Fill to max, boil, discard the water, then rinse, do this three times to remove manufacturing dust, etc. This will shorten the life of the element. [. . . ]