User manual RUSSELL HOBBS 14993

[. . . ] 4 Don't iron clothing while it's being worn ­ you'll burn or scald the wearer (this is not a joke ­ I've seen it happen). 5 Don't touch the soleplate, and keep away from the steam coming from it. 8 Use the iron on a stable, level, heat-resistant surface, preferably an ironing board. 9 Don't leave the iron unattended while plugged in, or while it's standing on the ironing board. [. . . ] set the temperature (#3) 15 Turn the temperature control to bring the temperature you want opposite the notch. 16 When the iron reaches the temperature you set, the thermostat light will go out. It'll then cycle on and off as the thermostat operates to maintain the temperature. temperature setting guide label marking temperature dot setting j cool ­ nylon, acrylics, polyester · k warm ­ wool, polyester mixtures ·· l hot ­ cotton, linen · · ·/max i do not iron , If the instructions on the fabric label differ from this guide, follow the instructions on the label. 3 reducing temperature 17 Reducing the temperature takes a bit longer, as the element has to lose the heat it has built up, so be patient. It's best to organise your ironing so that you don't need to reduce the temperature ("preparation" page 3, point 2). 18 When steam ironing, you must set the temperature control at S or higher (#3). 19 If you don't, you'll get water on your clothes, not steam. 26 You may initially have to press it 2 or 3 times to pump water through the system. 27 Don't try to use the shot of steam function at temperatures below S on the temperature control. 31 You may initially have to squeeze 2 or 3 times to pump water through the system. 32 Leave 4 seconds between shots, to let the temperature build up. steam ironing spray shot of steam dry ironing 33 If you want to dry iron, empty the reservoir first, to avoid spontaneous bursts of steam: a) Unplug the iron. d) Carefully, turn the iron upside down, and empty the water into the sink/basin. 35 Wait till the thermostat light goes out, then start ironing. vertical steaming 36 Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics. 37 Check that there's adequate ventilation behind the fabric, otherwise moisture may build up, causing mildew. 38 Check that there's nothing behind the fabric that may be damaged by the steam. 44 Press the S button (you're using the "shot of steam" function vertically). 45 You may have to squeeze 2 or 3 times to pump water through the system. 46 Leave 4 seconds between shots, to let the temperature build up. after use 47 Unplug the iron. 50 Carefully, turn the iron upside down, and empty the water into the sink/basin. 52 When it's cold, wipe off any moisture, and wind the cable round the heel. [. . . ] If it's not working, read the instructions, check the plug fuse and main fuse/circuit breaker. If that doesn't solve the problem ­ ring Customer Service ­ they may be able to offer technical advice. If they advise you to return the product to us, pack it carefully, include a note with your name, address, day phone number, and what's wrong. If under guarantee, say where and when purchased, and include proof of purchase (till receipt). [. . . ]