User manual RUSSELL HOBBS 2200W PET CYCLONIC

[. . . ] 9 Keep an eye on the cable, so it doesn't catch on anything, or trip anyone up. 10 If you're using the cleaner on stairs, sit it where it can't topple, and keep it below you, so if it does topple, it won't land on you. 12 Unplug the cleaner and rewind the cable when not in use, before moving and before cleaning. 13 Don't use the cleaner if the bag is full ­ switch off, unplug, and replace it. [. . . ] Use the big brush for the daily clean, the turbo for the weekly deep clean 4 small brush use it to remove pet hair, lint, and dust from blinds, curtains, and upholstery; to brush/clean awkward corners. crevice tool as the name implies, down the sides of upholstery, in awkward spaces, nooks, and crannies nothing else can reach. fabric tool use this to clean fabric upholstery, curtains, and other hanging fabrics toolbox 13 Press the dimpled button between the hose inlet and the indicator to unlock the toolbox. It has spaces for the small brush, crevice tool, and fabric tool. tubes 14 Fit the extendable tube to the nozzle for floors, carpets, or hard to reach places: a) push the tube release towards the narrow end of the tube, and keep it pressed b) pull out as much of the inner tube as you need ­ if you're done, push it back c) return the tube release to the locked position 15 Push the wide end of the extendable tube on the end of the nozzle. 16 Choose a tool, and push it on the narrow end of the tube. suction control 17 There are two ways to control the suction: a) The suction control on top of the cleaner ­ slide it towards max to increase the cleaning power, towards min to decrease the power. b) The suction control on the nozzle ­ move it away from the nozzle for maximum suction, towards the nozzle to reduce suction. plug in caution If you've accidentally pressed the on/off switch, the cleaner could come on when you plug it in. 18 Plug the cable into a socket near the area to be cleaned (switch the socket on, if it's switchable). 19 Press and release the on/off switch 3, to turn the cleaner on. switching on cleaning 20 Move the tool over the surface, cleaning a small area at a time. 21 When you move to a new area, overlap the previous area, to make sure none of the surface is missed. switching off 22 If you've finished, if you want to change tools, or if you just want to stop, press and release the on/off switch 3, to turn the cleaner off. 25 Stand clear of the cable, and press the cable rewind button C, the cable will rewind. If it catches on anything, stop pressing, and it'll stop rewinding. 27 We've tried not to make it too powerful, to avoid wrecking your home, so you may need to push the plug end into the storage area manually. 5 finished cleaning? indicator window 28 A red bar will move into the indicator window if the bag is full, or if there's a blockage. Stop, switch off, unplug, replace the bag, or clear the blockage. remove the bag 29 You don't have to replace the bag after each use, but you do have to keep an eye on the indicator, and change the bag when it's full, otherwise you'll choke the cleaner. 30 Switch off, unplug, and leave the cleaner for a minute, to let the dust settle. 31 Squeeze the locks on the hose end, and pull the hose out of the cleaner ­ this'll keep the hose out of your way. 32 Squeeze the door release towards the hose inlet, and raise the door, to expose the bag. 33 Grip the top of the cardboard mount, and slide it up and out of the bag holder, then lower the bag gently into the dustbin. . , Don't handle the bag ­ if you squeeze it, you'll eject the contents over your newly cleaned floor. The bag takes quite a pounding from the suction of the cleaner, and from the dust and dirt hitting its walls. Oils from your skin will weaken it further, so it might burst inside the cleaner. check the pre-motor filter 35 While the bag's out of the way, you should check the pre-motor filter. 36 Slide the filter holder up and out of its retaining rails at the rear of the bag compartment. [. . . ] 52 To refit it, or to fit the spare, simply drop it into the space under the grille. 53 Fit the lugs on the grille into the holes in the cleaner, close the grille, and check that the grille release clicks into place. cleaning the cleaner 54 Switch the cleaner off and unplug it before cleaning. A dab of washing-up liquid will remove stubborn stains, but clean it off afterwards, or it may stain. 58 Wipe the tools with a damp cloth, or hand wash in warm soapy water. [. . . ]