User manual RUSSELL HOBBS DELUXE COFFEE MAKER 18118

[. . . ] 14 Don't try to adjust the metal band round the carafe, you'll break the glass. 15 Keep the coffee maker and the cable away from hotplates, hobs or burners. 16 Don't use accessories or attachments other than those we supply. 17 Don't use the coffee maker for any purpose other than those described in these instructions. [. . . ] 28 To prevent the filter holder overflowing, replace the carafe on the stand within about 20 seconds. This may not sound much, but you'll find it's more than enough time to pour a couple of cups of coffee. 29 When you replace the carafe on the stand, the non-drip valve opens, to let any remaining coffee through. 4 keep warm 30 When the coffee maker has finished brewing, it'll automatically go into keep warm mode. 31 The X light will flash, and the hotplate will keep the carafe warm for up to 2 hours. 32 The display will change to 0:00, then it'll count up , to show you how long the coffee has been sitting. auto shut-off 33 After 2 hours, it'll turn the coffee maker off. In our experience, chemical changes in the coffee liquor start to affect the flavour after about an hour . 35 While it's probably still drinkable, it's not at its best, so we suggest you pour it away and make a fresh pot. 36 When the coffee runs out, or if you decide you don't want any more, press the X button ­ the X light will go out. 37 Unplug, and let the coffee maker and carafe cool down fully before cleaning, or for about 10 minutes before refilling. caution raising the lid before the coffee maker has cooled down may release steam, creating a scald hazard finished? brew strength Y 38 Use this feature if you're brewing less than 5 cups of coffee. It slows the brewing process, so your coffee will have the same strength as coffee from a full carafe. 39 You may press the brew strength button Y before or during the brewing process, to activate or deactivate the brew strength feature. 40 Press the Y button to activate the brew strength feature, the Y light will glow and a "smiley" mug will show in the top left of the display. 41 Press the Y button again to deactivate the brew strength feature, the Y light will go out, and the "smiley" mug will disappear from the display. a) the display will show AM for morning, and PM for afternoon b) press the h/min button, and keep it pressed till the display flashes (2 seconds) c) press and release the h/min button till the correct hour is shown (hold it down to "fast forward" the display) d) press and release the T button ­ the minutes side of the display will flash e) press and release the h/min button till the correct minute is shown f) leave the controls alone for 5 seconds ­ the display will settle at the correct time , If you overshoot, you can't step back. Either go right round (24 hours or 60 minutes), or unplug the coffee maker, to reset the display to 12:00 AM. 45 The clock will retain its settings till the coffee maker is unplugged. 5 coffee later 46 Set the timer to the time you want to start brewing. a) the display will show AM for morning, and PM for afternoon b) press and release the T button c) the display will show ­ : ­ ­ d) press and release the h/min button till the correct hour is shown (hold it down to "fast forward" the display) e) press and release the T button ­ the minutes side of the display will flash f) press and release the h/min button till the correct minute is shown g) leave the controls alone for 5 seconds ­ the display will settle at the correct time , If you don't press the h/min button within 5 seconds, the coffee maker will revert to "normal", and show the time. 47 The timer will retain its settings till the coffee maker is unplugged. It'll reset to ­ : ­ ­ next time you plug it in. activation 48 You've set the clock, you've set the timer ­ now you need to activate it. [. . . ] To replace the plug, fit the green/yellow wire to E or E, the blue wire to N, and the brown wire to L. Don't use a non-rewireable plug unless the fuse cover is in place. If you remove the plug, dispose of it. wheelie bin symbol To avoid environmental and health problems due to hazardous substances in electrical and electronic goods, appliances marked with this symbol mustn't be disposed of with unsorted municipal waste, but recovered, reused, or recycled. service If you ring Customer Service, please have the Model No. If it's not working, read the instructions, check the plug fuse and main fuse/circuit breaker. [. . . ]