User manual RUSSELL HOBBS SLIPSTREAM IRON 2200W 15129

[. . . ] 2 18 Don't use the iron for any purpose other than those described in these instructions. 19 Take care not to scratch the soleplate ­ avoid buttons, zips, etc. 20 The iron has a protective thermal fuse, which will blow if it overheats. If this happens, the iron will stop working, and must be returned for repair. [. . . ] 3 reducing temperature 18 This takes a bit longer, as the iron has to lose the heat it has built up, so be patient. It's best to organise your ironing so that you don't need to reduce the temperature. 19 When steam ironing, you must set the temperature control at S or higher. 20 If you don't, you'll get water on your clothes, not steam. 21 Turn the steam control to the setting you want, S = no steam, # = high steam (#3). 23 This works with dry or steam ironing, as long as there's water in the reservoir. 27 Press the * button ­ you may have to press it 2 or 3 times to pump water through the system. steam ironing spray shot of steam 28 This works with dry or steam ironing, as long as there's water in the reservoir, and the temperature is above S. 32 Press the ~ button ­ you may have to press it 2 or 3 times to pump water through the system. 33 Leave 4 seconds between shots, to let the temperature build up. dry ironing 34 If you're going to be dry ironing for 20 minutes or more, empty the reservoir first, to avoid spontaneous bursts of steam. 4 vertical steaming 37 Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics. 38 Check that there's adequate ventilation behind the fabric, otherwise moisture may build up, causing mildew. 39 Check that there's nothing behind the fabric that may be damaged by the steam. 44 Press the ~ button (you're using the shot of steam function vertically). 45 You may have to press it 2 or 3 times to pump water through the system. 46 Leave 4 seconds between shots, to let the temperature build up. after use 47 Turn the temperature control to ·, turn the steam control to S. 50 Hold the iron over a sink, turn it upside down, and drain the water from the reservoir. 53 When it's cold, wipe off any moisture, and close the water inlet cover. 54 Store the iron on its heel, to avoid corrosion and damage to the soleplate. [. . . ] To replace the plug, fit the green/yellow wire to E or E, the blue wire to N, and the brown wire to L. Don't use a non-rewireable plug unless the fuse cover is in place. If you remove the plug, dispose of it. wheelie bin symbol To avoid environmental and health problems due to hazardous substances in electrical and electronic goods, appliances marked with this symbol mustn't be disposed of with unsorted municipal waste, but recovered, reused, or recycled. service If you ring Customer Service, please have the Model No. If it's not working, read the instructions, check the plug fuse and main fuse/circuit breaker. [. . . ]