User manual SIMA SK-200

[. . . ] STS Titanium Power Inverters Inverter Installation Safety Kit for 1000 ­ 1500 ­ 2500 Watt Inverters General: The Inverter Installation Safety Kit is designed for installation of DC to AC power inverters up to 2500 watts. The wires and connectors included with this kit will improve the performance and extend the useful life of the DC to AC power system which includes the vehicle's batteries and charging system, the cable connectors, the power inverter and the load (TV's. [. . . ] These are to be used if your power inverter has the screw-down terminals. Instead of tightening directly to the wires, using these connectors will prevent loosening over time. Make sure to use the grommets to protect the red and black wires when going through holes drilled in metal. Drill holes for routing the red (+) wire and black (-) wires from the battery into the vehicle. Make sure to use black rubber grommets to protect the wires from rough metal edges which could strip or cut the wires and cause a short circuit. Strip back insulation 5/8" on ends of wires. Common sense: Never work on electrical wiring in the rain or while drinking or under medication. The last connection is always the connection to the positive terminal of the battery. Warranty: The components of the safety kit ­ excluding the fuses - are warranted for one year to date from the date of purchase. Before Starting Installation, Turn Power Inverter Off! Disconnect red positive (+) cable from Battery THESE INSTRUCTIONS ARE FOR NEGATIVE GROUND 12 VOLT ELECTRICAL SYSTEMS (The negative terminal of the battery is connected to the chassis or engine housing) 1. Crimp or solder connectors to both ends of short red wire and one end of long red wire and one end of black and green wires. Most Power Inverters can be mounted horizontally, vertically or upside down. Place connector on short red wire on fuse end on post nearest battery. Replace fuseholder cover and secure cover with cable ties or electrical tape. [. . . ] RECHECK CONNECTION AND MAKE SURE THE RED WIRE OR ITS CONNECTORS ARE NOT TOUCHING ANY METAL PARTS OF THE VEHICLE OR THE BLACK WIRE CONNECTORS. Turn the Power Inverter ON. Please note that this Safety Kit is a patent pending design and is an exclusive product of SPC Subsidiary Corporation 140 Pennsylvania Ave. [. . . ]