User manual SIMA SPM-13N

[. . . ] Trouble Shooting Problem No Indicator Lights Charge Power Possible Cause/Solution Confirm that the AC or cigarette adapter is firmly connected at both ends. Check fuse in car cord (un-screw tip of the cigarette lighter adapter. · No battery inserted · Battery is already fully charged. Power Light Only Charge Power · Battery mounted incorrectly; remove and remount battery. [. . . ] The charger will become slightly warm in normal use, but if contained, heat may damage the charger and battery pack. DO NOT allow moisture of any kind to come in contact with the charger. DO NOT store the charger where it may be exposed to extreme temperatures; avoid placing in direct sunlight. High temperatures can shorten the life of electronic devices, damage batteries and warp metal or plastics. DO NOT drop the unit ; a severe jolt can cause permanent damage and is not covered by the warranty. Wipe the body of the unit with a clean cloth, lightly dampened with mild detergent. Use a clean cloth, lightly dampened with rubbing alcohol to clean the metal contacts. Parts and Components notch Step 1 - Connect to AC Power Supply 1 Plate A To 120V AC outlet notch See note on flip-up door below Power Input jack Plate B notch Connect the AC adapter plug to the Power Input jack on the rear of the SPM-13N. ( See diagram above. ) The red Power indicator light will turn on. Power Input jack 12V DC Car Power Supply 2 4 3 Plate C To car cigarette lighter 1. Adapter plate latch Note: Adapter plates B and C each have a flip-up door for use with certain batteries. See flip-up door for listing of battery types. Connect the 12V DC car cord plug to the power input jack on the rear of the SPM-13N. Plug the cigarette lighter adapter into the cigarette lighter socket of the vehicle. (See diagram above. ) The red Power indicator light will turn on. Step 2 - Mounting the Adapter Plates Some battery models will require the use of an adapter plate (A, B or C). Consult the battery chart in this manual to determine which adapter plate your camcorder battery requires. Step 3 - Mounting the Batteries To install the battery - Align the contacts on your battery with the appropriate contacts on the charger. Typically you can install the battery onto the charger plate the same way you install the battery onto your camcorder. TIP: For some battery models, you will press the battery straight down and then slide it up, away from the indicator light, (Fig. On others you will slide the battery up and press it down (Figs. 2 and 3). [. . . ] If the camcorder does operate, leave the power on for 30+ minutes, then remove the battery and put it on the charger. The charger should go into the charge mode indicated by the blinking green Charge Status indicator. Charging (flashing) Charged (steady) It is recommended, however, that you leave the battery connected to the charger for another 30 mintutes to ensure a full or "topped off"charge. Warning: For use with lithium ion batteries only!DO NOT use with Nickel Cadmium (NiCd) or Nickel Metal Hydride (NiMH) batteries [. . . ]