User manual SMEG BLF01RDEU

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SMEG BLF01RDEU. We hope that this SMEG BLF01RDEU user guide will be useful to you.


SMEG BLF01RDEU : Download the complete user guide (5527 Ko)

You may also download the following manuals related to this product:

   SMEG BLF01RDEU (5532 ko)
   SMEG BLF01RDEU (5532 ko)
   SMEG BLF01RDEU (5532 ko)
   SMEG BLF01RDEU (1140 ko)
   SMEG BLF01RDEU (5534 ko)
   SMEG BLF01RDEU (5531 ko)
   SMEG BLF01RDEU (5531 ko)
   SMEG BLF01RDEU (5532 ko)
   SMEG BLF01RDEU (5535 ko)
   SMEG BLF01RDEU (5535 ko)
   SMEG BLF01RDEU (5530 ko)
   SMEG BLF01RDEU (5532 ko)

Manual abstract: user guide SMEG BLF01RDEU

Detailed instructions for use are in the User's Guide.

[. . . ] • Make sure that the electrical information on the rating plate agrees with the power supply. • Make sure not to cause damage to the electrical components (e. g. Contact the Authorised Service Centre or an 4 electrician to change the electrical components. • Connect the mains plug to the mains socket only at the end of the installation. [. . . ] Turn the Temperature regulator toward lower settings to obtain the minimum coldness. Turn the Temperature regulator toward higher settings to obtain the maximum coldness. If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Switching off To turn off the appliance, turn the temperature regulator to the "0" position. Temperature regulation The temperature is regulated automatically. However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: • room temperature, • how often the door is opened, • the quantity of food stored, • the location of the appliance. DAILY USE Freezing fresh food The freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time. To freeze fresh foods it is not necessary to change the medium setting. Place the fresh food to be frozen in the middle compartment For a faster freezing operation, turn the temperature regulator toward higher settings to obtain the maximum coldness. In this condition, the refrigerator compartment temperature might drop below 0°C. If this occurs reset the temperature regulator to a warmer setting. Storage of frozen food When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run at least 2 hours on the higher settings. In the event of accidental defrosting, for example due to a power failure, if the power has been off for longer than the value shown in the technical characteristics chart under "rising time", the defrosted food must be consumed quickly or cooked immediately and then re-frozen (after cooling). Thawing Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temperature, 6 depending on the time available for this operation. Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer. To make these adjustments gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Temperature indicator For proper storage of the food the refrigeration is equipped with temperature indicator. If accessible, clean the condenser and the compressor at the back of the appliance with a brush. General warnings CAUTION!If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. 10 TROUBLESHOOTING WARNING!Refer to Safety chapters. What to do if. . . Problem The appliance does not operate. The melting water outlet is not connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray. 11 Problem The temperature in the appliance is too low/too high. Possible cause The temperature regulator is not set correctly. There is no cold air circulation in the appliance. Solution Set a higher/lower temperature. Let the food products temperature decrease to room temperature before storage. Make sure that there is cold air circulation in the appliance. If the advice does not lead to the desired result, contact the nearest Authorised Service Centre. Closing the door 1. Contact the Authorised Service Centre. Replacing the lamp The appliance is equipped with a longlife LED interior light. Contact your Authorised Service Centre. INSTALLATION Positioning This appliance can be installed in a dry, well ventilated indoor where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Climate class SN N ST Ambient temperature Climate class T Ambient temperature +16°C to + 43°C +10°C to + 32°C +16°C to + 32°C +16°C to + 38°C 12 Some functional problems might occur for some types of models when operating outside of that range. The correct operation can only be guaranteed within the specified temperature range. [. . . ] Attach the appliance to the niche with 4 screws. E E I B I 8. Make sure to remove the part DX, in the case of right hinge, SX in opposite case. 10. Loosen the screws of the part (G) and move the part (G) till the furniture sidewall. 15 Ha G H Hc 14. Open the appliance door and the kitchen furniture door at an angle of 90°. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE SMEG BLF01RDEU




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SMEG BLF01RDEU will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.