User manual SMEG C92IPBL9

[. . . ] INSTRUCTIONS FOR USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SAFETY PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ENVIRONMENTAL CARE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 3. 1 Our environmental care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If the saucepan recognition function is activated in spite of the saucepan or frying pan on the cooking zone being smaller than the zone itself, only the necessary energy will be transmitted. Saucepan recognition limits: The minimum diameter of the saucepan base is indicated by a circle inside the cooking zone. Pans with smaller diameters risk not being detected and therefore not activating the inductor. 6. 8 Residual heat If the cooking zone is still hot after being switched off, the symbol will appear on the display. Supervise children carefully as they cannot readily see the indication of residual heat. The cooking zones remain hot for a certain period of time even after they have been turned off. Make sure that children never touch the hob. 6. 9 Heating accelerator Each cooking zone is equipped with a heating accelerator that allows to supply the maximum power for a time that is proportional to the selected power. Turn the knob to the left to the “A” position and then release; the symbol appears on the display. The power level can be increased at any moment, the “maximum power” period will automatically be modified. If the power is reduced, turning the knob anti-clockwise, the heating accelerator will automatically be disabled. 47 Instructions for the user 6. 10 Booster function The booster function allows to activate the cooking zone at maximum power as long as 10 minutes. It can be used to bring a large quantity of water to a boil rapidly or to broil meat. Turn the knob clockwise to the “P” position for two seconds and then release; the symbol will appear on the display. After 10 minutes the booster function will automatically be disabled and cooking will continue at power level “9”. The booster function has priority over the heating accelerator function. 6. 11 Power management The hob is fitted with a power management module that optimises/limits consumption. If the overall set power levels surpass the maximum limits permitted, the electronic circuit board will automatically manage the power supplied by the hot plates. The module will try to maintain the maximum possible power levels supplied and the levels imposed by the automatic management will appear on the display. The flashing of a power indicates that it will automatically be limited to a new level selected by the power management module. Priority is given to the last zone set. 6. 12 Control lock The control lock is a device that protects the appliance from accidental or inappropriate use. With all cooking zones turned off, simultaneously turn the first two knobs to the left (position “A”). Keep them turned until the symbols , appear on the display, then release the knobs. In order to remove the control lock repeat the same operations previously described. If the knobs have been kept rotated in the “A” position for more than 30 seconds a fault message will appear on the display. After a prolonged period of interruption to the power supply, the control lock will be deactivated. [. . . ] Removing the middle glass panels: • (pyrolitic models) there are two middle glass panels attached using 4 small locks. • (other models) an intermediate glass panel may be present; if so, remove it by lifting it upwards. Cleaning: • It is now possible to clean the external glass panel and the panels removed previously. In case of stubborn dirt, wash with a damp sponge and neutral detergent. Replacing the glass panels: • Replace the panels in the opposite order to which they were removed. • Reposition the internal glass panel, taking care to centre and insert the 4 pins attached to the glass into their slots in the oven door by applying slight pressure. 63 Instructions for the installer 11. [. . . ]