User manual SMEG CR312P

[. . . ] Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient. Installation and the electrical connection must be carried out by a qualified technician according to the manufacturer's instructions and in compliance with the local safety regulations. Clean the inside of the appliance before using it. SAFEGUARDING THE ENVIRONMENT 1. Packing The packing material is 100% recyclable and bears the recycling symbol. [. . . ] If you have purchased a model with antibacterial filter, the filter should be fitted in place now. When the appliance is switched on for the first time, the acoustic signal sounds and the red light (10) flashes, indicating that the temperature inside the freezer is still not cold enough for introducing food. The acoustic signal can be deactivated by pressing the button (11) on the control panel. Note: · 4-5 hours are required for the refrigerator compartment to reach a temperature suitable for storage. · Ambient temperature, frequency of door opening and position of the appliance can affect the temperature inside the two compartments. These factors should be taken into account when setting the thermostat position. · The space between the shelves and the rear wall of the refrigerator ensures the free circulation of air. · Do not place food in direct contact with the rear wall of the refrigerator compartment. · Storing vegetables with high water content can cause condensation to form: this does not affect correct appliance operation. Storing food in the refrigerator compartment Place the food as shown in the figure. Dairy products, cheese Temperature adjustment The temperature is factory set to +5°C (display 7). · Bend the ice tray slightly to facilitate removal of the cubes. 26 MAINTENANCE AND CLEANING Before carrying out any cleaning or maintenance operation, switch the product off by pressing button (1) on the control panel for 3 seconds, then unplug the appliance or disconnect it from the power supply. Cleaning the freezer compartment Defrosting of the freezer compartment is completely automatic. If you wish to clean the compartment, switch the appliance off as previously indicated and proceed as follows: 1. Open the freezer door and remove all the food, wrapping it close together in sheets of newspaper and put in a very cool place or in a portable cooler. Clean the inside of the freezer with a sponge soaked in a solution of lukewarm water and/or mild detergent. Reconnect the appliance to the power supply and press the button (1) again for 3 seconds. An acoustic signal (temperature alarm) will sound; to deactivate it, press the button (11). Note: · For a more thorough cleaning of the freezer compartment the glass shelves can be removed by slightly lifting the front above the stop and pulling outwards. · If the compartment is not used for prolonged periods, it is advisable to leave the freezer door open to prevent the formation of mould, odours and oxidation. Cleaning the refrigerator compartment Refrigerator compartment defrosting is completely automatic. Droplets of water on the rear wall inside the refrigerator compartment indicate that the automatic defrost phase is in progress. [. . . ] "Faulty refrigerator sensor" alarm (red led (10) flashing, acoustic signal activated and the letter C or E is shown on the freezer display) - A refrigerator compartment temperature sensor is faulty, but the appliance continues to work with an emergency procedure. Note: · If the front edge of the appliance is hot at the door seal edge, this is not a fault and prevents the formation of condensation. · If the temperature cannot be adjusted, make sure the control panel lock is not activated. 30 AFTER-SALES SERVICE Before contacting the Customer Care Centre: Switch the appliance on again to see if the problem has been eliminated. If it has not, switch off the appliance and repeat the operation after one hour. [. . . ]