User manual SMEG CR322ANFL

[. . . ] Call the authorised Service Centre. Printed in Italy 03/13 The control panel is switched off, the appliance does not work. The appliance could be in On/Standby mode. Door alarm active It is activated when the refrigerator compartment door remains open for a prolonged period of time. There is water on the bottom of the refrigerator compartment. The front edge of the appliance, at the door striker seal, is hot This is not a defect. Malfunction alarm The alarm indicates a fault in a technical component. Read the instructions carefully before using the appliance. [. . . ] Before all cleaning or maintenance procedures, unplug the appliance from the mains or disconnect the electricity supply. CHANGING THE BULB OR LED (depending on the model) Always unplug the refrigerator before replacing any light bulbs, then follow the relevant instructions in accordance with the type of lighting fitted in your appliance. Only use bulbs of the same type, which can be requested from the After-Sales Service and authorised dealers. 2. The lamp has a bayonet bulb and needs to be pulled out, not unscrewed, following the directions of the arrows as indicated. 3. After the new bulb has been inserted, replace the lamp cover and wait five minutes before plugging the appliance back in. Lighting type 2) To remove the light bulb, turn anticlockwise as shown in the figure. Wait for 5 minutes before reconnecting the appliance. 2 1 Lighting type 3) If the product has LED lighting which is in need of replacing, contact the After-Sales Service for assistance. LED lights last longer than normal bulbs, they illuminate better and are more environmentally friendly 10 WHEN THE APPLIANCE IS NOT IN USE Unplug the appliance from the mains, then empty, defrost (if necessary) and clean it. Leave the doors ajar, so that air can circulate inside the compartments. This will prevent the formation of mould and bad odours. DURING BLACKOUTS Keep the doors closed to allow the stored food to stay cold as long as possible. If the blackout persists, the blackout alarm may sound (depending on the model). REFRIGERATOR COMPARTMENT The refrigerator compartment is designed for the storage of fresh food and beverages. Droplets of water on the rear wall of the compartment indicate that the periodic automatic defrost cycle is in progress. After defrosting, replace the drain pipe, making sure that no water is left in it. Switch the appliance back on and place the food back inside. 12 MEAT & FISH BOX (depending on model) The Meat & Fish box was designed specially to keep foods fresher for longer, without altering nutritional values or original freshness. Do not store fruit or vegetables in this box, as the temperature may drop below 0°C, causing water contained in the food to freeze. Temperature Adjustment The temperature inside the Meat & Fish box is indicated by the position of the arm on the door of the box, and depends on the general temperature of the refrigerator compartment. We recommend setting the temperature of the refrigerator compartment between +2° and +6°. To work out if the temperature inside the Meat & Fish box is correct, refer to the pictures below: When the arm points to the left, you need to raise the temperature in the refrigerator compartment. When the arm is in the middle, the temperature is ok. When the arm points to the right, you need to lower the temperature in the refrigerator compartment. Important: when the function is activated and foods with a high water content are present, condensation may form on the shelves. In this case, disable the function temporarily. To ensure correct operation of the product, adequate preservation of food and to optimise energy consumption, it is advisable not to remove the Meat & Fish compartment if the symbol (see Quick Guide) is not present on the control panel. In all other cases, the Meat & Fish compartment can be removed to obtain more space inside the refrigerator. Remove the drawer cover by releasing the bottom side clips (Figure 2). To reinstate the Meat & Fish compartment, make sure to refit the drawer cover before inserting the drawer and reactivating operation. Press the “Meat & Fish compartment function” button on the control panel for 3 seconds, until the yellow indicator goes off. To optimise energy consumption, it is advisable to deactivate the Meat & Fish compartment and remove its components (except the shelf above the crisper drawers). Removing the Meat & Fish compartment: Fig. [. . . ] To optimise energy consumption, we recommend you deactivate the “Zero Degrees” box and remove it. Clean the box and all its parts regularly, using a cloth and a solution of warm water and neutral detergent specifically formulated for refrigerator interiors (take care not to immerse the white plastic shelf underneath the box in water). Before cleaning the box (including the outside), remove the drawer so as to disconnect the box from the electricity supply. Never use abrasive detergents. AFTER-SALES SERVICE Before contacting the After-Sales Service: Switch the appliance on again to see if the problem has been solved. [. . . ]