User manual SMEG DIC4-1

[. . . ] INSTRUCTION MANUAL GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAMS Contents 1. 6. Safety and operating instructions ___________________________ 2 Installation and hook-up __________________________________ 5 Description of the controls ________________________________ 9 Operating instructions ___________________________________ 19 Cleaning and maintenance _______________________________ 31 Troubleshooting _______________________________________ 36 Thank you for choosing one of our products. You are advised to read this manual carefully; it contains all the information you need about the right conditions for the proper, safe use of your dishwasher. The individual sections are laid out to provide you with a step-by-step guide to all your appliance's functions; the texts are easy to understand and are complete with detailed illustrations. [. . . ] This does not mean that the wash program has been less effective than usual. PROGRAM DELAY The start of the washing program can be delayed by from 1 to 24 hours depending on the model, to program the dishwasher to operate at the preferred time of day (e. g. ● When the door is closed, the appliance will prewash the dishes, after which the count of the "program delay" set will begin. Models without display The start of the program can be delayed by 3, 6 or 9 hours. The button can be pressed again to select the delay required (the relative light comes on) or disable the option (lights off). Models with display The button can be pressed again to select the delay required, increasing it in onehour steps, with the duration shown on the display. 16 User instructions CANCELLING A PROGRAM IN PROGRESS • Open the door, taking care to avoid splashes of water, and hold down the PROGRAM SELECTION (3) button for a few seconds until the indicator lights for programs 4 and 5 illuminate simultaneously (marked "end"). • • Close the door. After approximately 1 minute the dishwasher will advance to the end of cycle. CHANGING THE PROGRAM To change the program in progress, simply open the door and select a new program. When the door is closed the dishwasher will automatically select the new program. TO SAVE ON ENERGY!…AND PROTECT THE ENVIRONMENT • Always use the dishwasher with a full load. • Use the washing program that is most appropriate for each type of load. • If available, connect the dishwasher to a hot water supply up to 60° C. TO REDUCE DETERGENT CONSUMPTION AND PROTECT THE ENVIRONMENT The phosphates contained in dishwasher detergents are harmful to the environment. To avoid using excessive amounts of detergent save on electricity as well, observe the following recommendations: • • Sort your dishes, washing delicate items separately from those more resistant to strong detergents and high temperatures. Do not pour detergent directly onto dishes. If the door must be opened while a wash cycle is in progress, the program will be interrupted. The corresponding light will continue to flash and a beeper will signal that the cycle has not been completed. You must wait about 1 minute before closing the door to restart the program. When the door is closed the program will continue from where it was interrupted. This operation should only be carried out if strictly necessary, as it could cause problems in running the program. 17 User instructions SWITCHING OFF At the end of the program the beeper sounds briefly and the lights of programs no. To switch off the dishwasher, open the door and press the ON/OFF button (1). ENERGY MANAGEMENT After 5 minutes of inactivity (wash cycle completed, stopped or set but not started), the dishwasher switches to standby mode to reduce energy consumption. In this mode, the dishwasher indicator panel (lights or display depending on model) functions more slowly (switch-on once every 5 seconds). REMOVING THE DISHES At the end of the wash program, wait at least 20 minutes before removing the dishes, to allow them to cool. To ensure that any drops of water left in the top basket do not drip onto the dishes still in the bottom basket, you are advised always to empty the bottom basket first. 18 User instructions 4. [. . . ] Shut off the water supply tap. BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE: • • • Check that there are no deposits of sludge or rust inside the water pipe: if there are, allow the water to run from the water supply tap for a few minutes. Reconnect the water intake hose and open the tap again. TROUBLESHOOTING MINOR PROBLEMS In some cases it is possible to remedy minor problems by referring to the following instructions: If the program fails to start, check that: • • • • • • • • • • • • • • 34 The dishwasher is connected to the electricity supply There is no power outage The water tap is open The dishwasher door is properly closed If water remains inside the dishwasher, check that: The drainage hose is not kinked The drainage trap is not blocked The dishwasher filters are not clogged If the dishes do not come out clean, check that: The correct amount of detergent has been added The salt container is not empty The dishes have been loaded correctly The selected program is suitable for the dish types and their degree of soiling All filters are clean and correctly installed The spray arm nozzles are not clogged There is nothing obstructing the rotation of the spray arms User instructions If the dishes fail to dry or remain dull, check that: • • • The rinse aid container is not empty The rinse aid dispenser setting is correct The detergent used is of good quality and has not lost its effectiveness (for example, through incorrect storage, with the box left open) If the dishes show signs of streaking, staining etc. , check that: • The rinse aid dispenser setting is not too high If there are visible traces of rust inside the tank: • the tank is made of stainless steel, and therefore any rust marks are due to external elements (fragments of rust from the water pipes, pots, cutlery etc. ). Check that the cap of the salt container is securely closed, and that the water softening setting is correct. • • If the problem persists after following the troubleshooting instructions above, call the nearest Authorised Service Centre. WARNING: any operations performed on the appliance by unauthorised technicians are not covered by the warranty and shall be paid for by the user. 35 User instructions 6. [. . . ]