User manual SMEG FA800PS9

[. . . ] 2 3 4 4 USAGE INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Display and Control panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Use of control panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Operating your Fridge . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Freeze Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Red warning lights will continue to light up until the problem is corrected/eliminated. In case the mains voltage is low, Alarm and LV will light red and audible alarm is released. Red warning lights will go off when mains voltage raises the appropriate level. Operating your Fridge After the appliance is plugged, all symbols will appear for 2 seconds, and then the startup values will appear as -18°C on freezer setting indicator and +5°C on cooler setting indicator. (Only press to activate the button you want to operate. ) Freeze Mode When would it be used?• For freezing a large amount of food (too large to be fitted in the Super freezer). • Press button F until letters "SF" and relative bar graphic light up. • If pressed on no button in 1 second, SF and bar graphics will flash 3 times and a beep sound will be released. • SF and relative bar graphics will be displayed during this mode. During this mode: • Freezer may be adjusted, Super Freeze will be cancelled and the selected setting values will proceed. • When "Super Freeze" is active, SF can be re-selected and cancelled by pressing on button F. Note: “Super Freeze” mode will be automatically cancelled after 24 hours or freezer sensor temperature is lower than -32 °C. • Whenever you press on this button, one bar comes on cooler bar graphic indicator and lower temperature will be set. (+8°C, +6°C, 5°C, +4°C, +2°C) • When you push the cooler button until +2°C (maximum cold) appears on the cooler setting indicator, and when you keep pushing, letters SC (Super Cool) will flash. • The temperature value selected before Holiday Mode, Super Freeze Mode, Super Cool Mode or Economical Mode is activated will remain the same when the mode is over or cancelled. Freezer Temperature Settings • Initial temperature value for Freezer Setting Indicator is -18°C. • When you first push this button, -20°C appears on the setting indicator of the freezer. • Whenever you press on this button, one bar comes on Freezer Bar Graphic Indicator and lower temperature will be set. ( -16°C, -18°C, -20°C, -22°C, -24°C) • When you push the freezer button until -24°C (maximum cold) appears on the Freezer Setting Indicator, and when you keep pushing, letters SF (Super Freeze) will flash. • The temperature value selected before Holiday Mode, Super Freeze Mode, Super Cool Mode or Economical Mode is activated will remain the same when the mode is over or cancelled. Your appliance will continue operating in this temperature value selected. Warnings about Temperature Adjustments • Your temperature adjustments will not be deleted when an energy breakdown occurs. • It is not recommended that you operate your fridge in environments colder than 10°C in terms of its efficiency. [. . . ] Change the present light bulb with a new one of not more than 15 W. (B) 4. Replace the light cover and after waiting 5 minutes plug the unit. (C) PART- 5. TRANSPORTATION AND CHANGING OF INSTALLATION POSITION Transportation and Changing of Installation Position • The original packages and foamed polystyrene (PS) can be concealed if required. • In transportation the appliance should be tied with a wide stripe or a strong rope. The rules written on the corrugated box must be applied while transporting. [. . . ]