User manual SMEG FL 102 AP

[. . . ] • In case the interior accessories are not correctly placed, rearrange them as described in chapter Description of the Appliance. The appliance should be professionally mounted by qualified technician and instructions are for his use only. We Care for the Environment • Our products use environmentally friendly packaging, which can be either recycled or disposed of in an environmentally friendly manner. • These instructions are printed either on recycled paper or chlorine free bleached paper. • When your appliance finally wears out, please try not to burden the environment with it; call your nearest authorised service agent. [. . . ] Behind the appliance there should be free space at least 200 cm² wide and above the appliance the high kitchen units should be at least 5 cm away from the appliance in order to assure adequate ventilation of the condenser unit. Class SN (sub-normal) N (normal) ST (sub-tropical) T (tropical) Ambient temparature from + 10°C to + 32°C from + 16°C to + 32°C from + 16°C to + 38°C from + 16°C to + 43°C Connection to Power Supply Connect the appliance with the cable and plug to the power supply socket outlet with a ground terminal (safety socket). Required nominal voltage and frequency are indicated on the rating plate. The connection to the mains supply and earthing have to be made according to current standards and regulations. The appliance resists temporary voltage tolerance up to -6 to +6 %. Description of the Appliance Shelf (1) (the number of shelves depend on model) Shelf can be optionally placed on the guides inside the appliance. If you want to remove it, slightly lift up the back part and pull it out. Glass shelves (some models only have them) are protected with plastic spacers. Before pulling the shelf Instructions for Use out, spacers must be moved towards you. Spacers can be also removed, however, it is better to keep them for any later transport. the coldest part of the shelves. Under the plate there is a channel and an outlet for defrost water. Regularly check the defrost water outlet and the channel, because they should never be clogged (as for example with food rests). If clogged, use a plastic straw and clean it. Bottle rack (in some models only) Bottle rack (number depends on model) is intended for storing the bottles. There are two installation positions available (horizontal or lifted in the front) thus enabling the positioning of bottles on the stopper as well. If you want to pull it out, simply lift its rear part and pull it towards you. Fruit and Vegetable Container (3) The container is on the bottom of the appliance under the glass shelf. It provides adequate humidity which has favourable effect on fruit and vegetables stored in it (less dehydration). Door Liner The door liner consists of various shelves or holders used for storing eggs, cheese, butter and yogurt as well as other smaller packages, tubes, cans etc. The lower shelf is used for storing bottles. Illumination in the Interior of the Refrigerator Warning! If the door contains storing shelves, install the rack in such position that the length of the bottles will not hinder the closing of the door. The rack may carry 9 bottles of 0, 75 l or more at the maximum (total weight max. 13 kg) – note the label underneath the thermostat box inside the appliance. The light for illuminating the interior of the appliance is on, when the door is opened. The operation of the light does not depend on the position of the thermostat knob. NOTE: • The appliance can be equipped with various accesories, depending on the model of the appliance. • Various accesories (spice container, tube holder or additional shelves) can be bought in authorised centres. Defrost Water Outlet (2) The interior of the refrigerator is cooled with cooling plate incorporated in the rear wall. Operation Control The appliance is controlled with thermostat knob, situated in the right upper part inside the appliance. ambient temprature affect temperature in the interior of the appliance (choose correct setting of the thermostat knob). [. . . ] • Sometimes unusual and stronger noise is heard, which is rather unusual for the appliance. − The appliance shall be placed and levelled firmly on solid base. − It should not touch the wall or kitchen units standing next to it. − Check the accesories in the interior of the appliance, they should be placed correctly in their positions; also check the bottles, tins and other vessels that might touch each other and rattle. Bulb Replacement Before replacing the light bulb, disconnect the appliance form the power supply. [. . . ]