User manual SMEG GW2145-6 ISTRUZIONI VARIE

[. . . ] GW2145 – GW1160 – GW4060 – GW4190 INSTRUCTION SHEET SELECTING THE WASHING PROGRAMME (GW4190 series only: give power supply by turning the main switch from position "0" to "I". [. . . ] After the cycle has been interrupted, the options available vary depending on conditions in the chamber: 1. If the temperature in the chamber is below 40°C: the door can be opened. If the door is closed again within 1 minute, the cycle can be restarted from the phase where it was interrupted, by holding down the Start/Stop button. If the temperature in the chamber is above 40°C: a RESET cycle is required since the door cannot be opened. DOOR OPENING Press the Door opening button: the appliance gives a beep when it receives the signal. Release the button and the door will open automatically after a few moments. RESET PROCEDURE Press the Functions and Start/Stop buttons and hold them down for about 2 seconds, until a beep is heard. + ALARMS LED MEANING When an alarm occurs: Led “Warning” on and display indication. [. . . ] For all the details concerning the correct and safe use of the devices in question, for the updated program table, for the interpretation of alarm messages and for the requirements for installation: Refer to the user manual - full version. 19510076804 Fogl. IT-EN GW2145-1160-4060-4190 Smeg S. p. A. [. . . ]