User manual SMEG K400X

[. . . ] Installation, Use and Maintenance Manual OVEN HOOD SCF00032 Introduction Dear Customer, we hereby thank you for choosing our Oven Hood and hope you will be satisfied with our product. provided by the manufacturer. When using it for the first time, make sure that the hood conveyor connected to the exhaust ducts of the oven is positioned correctly, to prevent vapour leakage. [. . . ] Installation All the materials, with the exception of silicone, used for installation must resist a temperature of 150 °C without generating strains and/or surface defects. 2. 1 - Positioning The Oven Hood must be positioned on the oven, after must be fixed by the two brackets, that will be fixed to the rear oven’s back (Fig. 2. 2 - Electrical connection The electrical must be carried out by qualified personnel in compliance with the European regulations The Ove is replaced, it must be compatible with the maximum power of the It is recommended to have the installation done by a qualified electrician in compliance with the regulations in force Attention!!!– The equipment must be earthed properly according to the safety regulations of the electrical system connection, single phase 220 – 230 V ~ 50/60 Hz, in force. electrician, force. system. fig. 1 2. 4 – Operation The Oven Hood will be turned on by the front switch (Fig. 3. – Before carrying out any maintenance operations, turn off the current by using the appropriate switch or disconnecting the plug. – Any maintenance operation must be carried out by qualified personnel only. Maintenance operations may include the removal of the rear cover or the front one. 3) and take care not to damage the electric cables when lifting the cover. To remove the rear cover unscrew the perimetric screws and lift the cover completely, taking care not to disconnect the electric cables. 3. 1 – Disassembling labyrinth filters To disassemble the filters, grab and slide them upwards so that they slip out of the lower guide. [. . . ] – Never use detergents containing: sand, caustic soda, acids or chlorides that might corrode the surface. – Carry out any cleaning operation cutting off the power supply first The hood must be cleaned by using a damp cloth with nonabrasive detergent and drying the surfaces with a dry cloth. 5. [. . . ]