User manual SMEG KCVB9SG

[. . . ] EN Specific Instruction Manual EN Installation instructions: EN Grease filter extraction instructions. Top removable glass Bottom removable glass 1)Top glass extraction phases: NB: Extract the bottom glass in the same manner. EN 2) Grease filter extraction: To remove the metal grease filter, follow the instructions carried in the General Instruction Booklet. EN Electronic control system instructions for use: Technical Features: · Power supply from mains: 230 VAC ­ 50/60 Hz · Power consumption in standby: 20 mA · Max. [. . . ] BOOST-SPEED mode is set to operate for 10 minutes: during which the display alternatively shows HI and the remaining time and the dot at the bottom right flashes every second. After 10 minutes the system automatically reverts to the previous speed setting. · 24H AIR CHANGE Starts the blower motor at a speed that provides a flow rate of about 100 m3/h. 24h AIR CHANGE cannot be enabled when either BOOST-SPEED or DELAY -OFF is enabled. · DELAY Enables and disables the hood's complete shutdown (motor+lights) after 30 minutes: during which the display alternatively shows the motor speed and the minutes remaining and the dot at the bottom right flashes every second. EN To disable the DELAY press the button again or stop the motor. · RESET FILTRI: Resets the filter saturation alarm if pressed for 2s when all the loads (motor+lights) are off. · If there is a CA filter alarm, EF appears on the display after 200h of operation. · REDUCE LIGHT INTENSITY · LIGHTS ON/OFF Turns the hood lights on and off at maximum intensity. [. . . ] filter saturation alarm EF flashes twice when enabled and once when disabled . EN · Press button 24 to enable/disable the remote control receiver; "tc" flashes twice on the display when the remote has been enabled and once when the remote control has been disabled. [. . . ]