User manual SMEG KE61X

[. . . ] · Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. · For Class I appliances, check that the domestic power supply guarantees adequate earthing. [. . . ] · Clean the hood using a damp cloth and a neutral liquid detergent. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. EN 9 9 CHARACTERISTICS - INSTALLATION FIXING OF THE HOOD UNDER THE CABINET · To drill the cabinet follow the indications given in the dimensional drawing in the chapter which regards hood dimensions. · To fix the hood onto the cabinet use the 44, 4 mm long screws inserting and tightening them from the inside of the cabinet. Connection to air outlet AIR OUTLET IN THE DUCTING MODE When installing the hood in ducting version, basing on the installer's choice, a rigid or a flexible pipe is used in order to connect the hood to the air outlet piping. · Open the metal grid and make sure that the conversion knob is in the ducting position. · Remove the charcoal filter if present. EN 1 10 0 AIR OUTLET IN THE RECYCLING MODE · Open the metal grid and make sure that the conversion knob is in the recycling position. (Hoods with two motors needs to be equipped with two charcoal filters). INSTRUCTIONS FOR OPENING AND REMOVING THE METAL GRILLE PANEL · To open the grille, pull the facia panel out into the operating position. · Press inwardly on the two slide catch fastners, located at each side of the grille near the facia panel, while pulling the grille panel onwards. · To remove the grille, release the right hand hinge pin from the slot along the casing and the grille can be removed. ELECTRICAL CONNECTION · Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. . EN 1 11 1 USE Control board 1 2 3 Lighting Motor Speed On/off lighting system. Minimum speed, particularly silent, continuous air exchange, suitable in presence of only few cooking vapours and odours. Medium speed, due to an optimum relation between hood extraction capacity and the noise level, it is suitable for most of the cooking conditions. [. . . ] The charcoal filter cannot be cleaned and should be replaced at least every six months or more frequently if the hood is used consistently. To replace the charcoal filter, support the filter with one hand, remove the round disk through the centre of the charcoal filter and rotate it till the filter will come away . [. . . ]