User manual SMEG KQ45X-1

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by the cooker hood. • In the event of damage to the power cable, it must be replaced by the manufacturer or by the technical service department, in order to prevent any risks. INSTALLATION USE • The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. [. . . ] • From inside the hood body, tighten the screws Vr to level the body. 11a Vr Connection AIR OUTLET IN A DUCTING HOOD VERSION When installing the hood in ducting version, basing on the installer’s choice, a rigid or a flexible pipe with a ø 150 or 120 mm is used in order to connect the hood to the air outlet piping. The pipe connection can be made on the upper part or on the rear side of the hood. Before connecting the hood to the air outlet ducting remove the lateral air outlet grid 8 and the plastic tube 7. The adapting flange 9 has to be removed only in case the connecting diameter is 150. REAR AIR OUTLET • When drilling the air outlet hole in the wall proceed in accordance with the scheme in the part concerning the wall drilling. • Use a pair of tongs when breaking the rear air outlet hole in the wall. • In case the connection is made by using a ø 120 mm pipe insert the reduction flange 9 on the hood body outlet. • Fix the metal cover 10 to the upper air outlet hole of the hood by using the screws supplied. UPPER AIR OUTLET • In case the connection is made by using a ø 120 mm pipe insert the reduction flange 9 on the hood body outlet. • Use a pair of tongs when removing the central part of the metal cover 10. Fix the cover to the air outlet hole of the hood by using the screws supplied. • Remove the charcoal filter if present. ø 150 9 ø 120 10 10 EN 1 15 AIR OUTLET IN A RECYCLING HOOD VERSION • In case the components requested for the recycling functioning have been removed earlier these have to be positioned again. • Make sure that charcoal filters have been placed inside the hood. 8 7 ELECTRICAL CONNECTION • Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. • Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan. EN 1 16 USE L1 L2 L3 L4 L T1 T2 Control panel T3 T4 But ton L Function Turns the lighting system on and off. Led - Press and hold for approx. [. . . ] • Press and hold the Delay button (T4) on the keypad for 5 seconds and the following will be displayed: • Leds (L1-L2-L3) flash twice – Activated Charcoal Filter saturation alarm ACTIVATED. • Leds (L1-L2-L3) flash once – Activated Charcoal Filter saturation alarm DEACTIVATED. CHANGING THE ACTIVATED CHARCOAL FILTER Resetting the alarm signal • Press button T1 (see the paragraph on Use). [. . . ]