User manual SMEG KSEIG36XU

[. . . ] Consult the cooktop or range installation instructions given by the manufacturer before making any cutouts. The installation of this rangehood must conform to the Manufactured Home Construction and Safety Standards, Title 24 CFR, Part 3280 (formerly Federal Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280). Four wire power supply must be used and the appliance wiring must be revised. [. . . ] • Failure to follow electrical requirements may result in a fire. EN 5 5 RECOMMENDATIONS AND SUGGESTIONS The Instructions for Use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. INSTALLATION • The manufacturer will not be held liable for any damages resulting from incorrect or improper installation. • Check that the main voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. • The electrical supply must be properly and sufficiently grounded. Connect the extractor to the exhaust flue through a pipe of minimum diameter 6”. • Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc. ). • If the extractor is used in conjunction with non-electrical appliances (e. g. gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. USE • • • • The range hood has been designed exclusively for domestic use to eliminate kitchen odors. Never use the hood for purposes other than for which it has ben designed. Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. • Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. • The hood should not be used by children or persons not instructed in its correct use. CARE • Switch off or unplug the appliance from the main supply before carrying out any maintenance work. • Clean and/or replace the Filters after the specified time period. • Clean the hood using a damp cloth and a neutral liquid detergent. . THERMAL PROTECTOR The range hood is equipped with a thermal protector to avoid overheating conditions. If the range hood shuts off in use, press the on/off button to return off range hood. Wait approximately 90 minutes, then press the on/off button to restart the range hood. EN 6 6 DIMENSIONS and MAIN PARTS Dimensions 1 /1 17 6” Min. 26 3/4” - Max. 39 3/8” 1 7/8” 13 3/4” 63 23 5/8” 5 7/8” 4 6/8” /8” 20 7/8” 35 3/8” 1/4” 3 20 /8” 9 27 /16 ” EN 7 7 Components Ref. [. . . ] • Remove the filters one at a time, supporting them with one hand and turning the safety knobs (pull and turn). Make sure that filters are completely dry before putting them into their seat. • Place the filters again into their seats and make sure that the handle of the filter remains outside. Activated charcoal filter (Recirculation version) REPLACING THE ACTIVATED CHARCOAL FILTER The filter is not washable and cannot be regenerated, and must be replaced approximately every 4 months of operation, or more frequently for particularly heavy usage. [. . . ]