User manual SMEG LBW105DS

[. . . ] WASHING MACHINE USER MANUAL LBW105DS BEFORE USING THE WASHING MACHINE, YOU SHOULD CERTAINLY READ THE INFORMATION IN USER’S MANUAL. CONTENTS CHAPTER-1: TECHNICAL SPECIFICATIONS CHAPTER-2: BEFORE USING WASHING MACHINE Safety warnings Recommendations CHAPTER-3: SETTING UP . . . . . Removing transport safety screws Adjusting adjustable stays Electrical connection Water inlet connection Water discharge connection CHAPTER-4: PRELIMINARY PREPARATION FOR LAUNDERING CHAPTER-5: CONTROL PANEL Detergent drawer Programme knob Spin speed selector knob Electronic display CHAPTER-6: OPERATING YOUR MACHINE Selecting programme Auxiliary functions Starting the programme Child lock Cancelling programme Finishing programme CHAPTER-7: WARNING SYMBOLS Warning of water cut-off/low mains water pressure Warning of clogged pump fitler CHAPTER-8: MAINTENANCE AND CLEANING OF YOUR MACHINE CHAPTER-9: PRACTICAL INFORMATION CHAPTER-10: TROUBLESHOOTING CHAPTER-11: AUTOMATIC FAULT WARNINGS AND WHAT TO BE DONE CHAPTER-12: DESCRIBING AND SAVING ENERGY 3 5 5 6 7 7 9 10 10 11 12 16 17 18 19 20 21 21 21 27 28 29 30 31 31 32 33 38 40 45 47 2 CHAPTER -1: TECHNICAL SPECIFICATIONS 2 3 4 1 1. Detergent drawer 2. Upper tray 3. Programme knob 4. Electronic display 5. Door 6. Cover of pump filter 5 6 8 9 10 7 7 7. Transport safety screw 8. Power cable 9. Discharging hose 10. Water inlet valve 7 7 3 CHAPTER -1: TECHNICAL SPECIFICATIONS Operating voltage / frequency (V/Hz) Total current (A) Water pressure (Mpa) Total power (W) Maximum dry laundry capacity (kg) Wringing revolution (rev / min) Programme number Dimensions (Height x Width x Depth) (mm) (220-240) V ~/50Hz 10 Maximum: 1 Mpa Minimum: 0. 1 MPa 1850 5 1000 15 845 x 597 x 416 4 CHAPTER -2: BEFORE USING YOUR WASHING MACHINE SAFETY WARNINGS SAFETY WARNINGS Do not use multiple receptacles or extension cord. In case of a breakdown of power cable, contact the nearest authorized service for replacing it. Do not plug-in or out the plug from the receptacle with wet hands to prevent electric shock. [. . . ] Dirty cotton, synthetic, colour and flax textiles can be washed together. Dirty, synthetic and synthetic-mixed shirts and blouses can be washed together. You can wash your dirty cotton, colour and flax textiles at 60°C in 60 minutes. You can wash your slightly dirty cotton, colour and flax textiles in 15 minutes that is a short period. Note: As the washing period is short, less amount of detergent is required to be used compared to other programmes. The programme period will increase if your machine detects instable loading. You can open the door of your machine 2 minutes after the completion of washing operation. (The duration of 2 minutes required to open the door of your machine is not included in the washing period. ) 15-SUPER RAPID 15 min. 30 2 2 Program duration, energy consumption and water consumption values may vary according to wash load weight and type, selected extra functions, tap water and ambient temperature 23 CHAPTER 6: OPERATING YOUR MACHINE AUXILIARY FUNCTIONS 1-Washing water temperature selection You can select the washing water temperature with the washing water temperature adjustment button. Whenever you select a new programme, the maximum washing water temperature is shown on the washing water temperature display. You can gradually decrease the washing water temperature between the maximum temperature and cold washing (--) by pressing washing water temperature adjustment button. If you have missed the washing water temperature you wanted, you can return to the intended temperature by continuously pressing the washing water temperature adjustment button. 24 CHAPTER 6: OPERATING YOUR MACHINE AUXILIARY FUNCTIONS 2-Auxiliary function for delay timer By using this auxiliary function, you can let your machine start washing after 1 hour to 23 hours. To use auxiliary function of delay timer: - Press time delay button once. - Press on time delay button until the time, on which you want washing operation to be started. - To activate the time delay you have selected in the programme, you may press on any auxiliary function button you like except “Start/Pause” button. If you have skipped the time delay you want to set, you can go back to the time desired by keeping pressed on delay timer button. If you want to cancel the delay timer, you are required to press the delay timer button once. To run delay timer function, your machine is required to be operated by pressing on Start/Pause button. As soon as you start your machine, the count down process will start on the electronic display based on the delay period you have selected. 25 CHAPTER 6: OPERATING YOUR MACHINE AUXILIARY FUNCTIONS 3. Auxiliary function for easy ironing Your laundry will be less creased if the easy ironing auxiliary function is pressed/selected. 26 CHAPTER 6: OPERATING YOUR MACHINE STARTING THE PROGRAMME Start/Pause button By pressing on Start/Pause button, you may start the programme you have selected, suspend a running programme. If you switch your machine to pause mode, electronic display will blink. When you start your machine, the following symbols for the programmes you have selected will be available on electronic display. - Programme ending time or programme delay time based on your selection. - Symbol of locked door. 27 CHAPTER 6: OPERATING YOUR MACHINE CHILD LOCK Child lock To avoid programme flow from being affected if programme knobs are pressed or programme knob is turned when performing washing operation in your machine, child lock is available. The child lock will become active after the first and second function buttons on the control panel are pressed at the same time and for longer than 5 seconds. When it becomes active the electronic display will blink “CL” and child lock light will light up. If pressed any button while child lock is active, child lock light will blink on the electronic display. When any of the programmes is running and child lock is active, if another programme is selected after programme knob is switched to 0 position, the programme already running will resume. To deactivate it, it will be sufficient to press on the same buttons for more than 5 seconds. [. . . ] (**) See the chapter regarding installation of your machine. 41 CHAPTER -10: TROUBLESHOOTING FAULT POSSIBLE CAUSE REMOVING METHODS Press on Start/Pause button. To eliminate foam formation, mix a spoon of softener with half litres of water, and pour the mixture in the detergent drawer. Use detergents produced only for automatic washing machines in your machine. Select the programme appropriate for the contamination degree of your laundries. [. . . ]