User manual SMEG PV164CBBN

[. . . ] Failure to follow the instructions provided in this user guide regarding the cleaning of the hood and filters will lead to the risk of fires. Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks. We will not accept any responsibility for any faults, damage or fires caused to the appliance as a result of the nonobservance of the instructions included in this manual. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). [. . . ] Any frying must be done with care in order to make sure that the oil does not overheat and ignite. The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For further detailed information regarding the process, collection and recycling of this product, please contact the appropriate department of your local authorities or the local department for household waste or the shop where you purchased this product. Additional Installation Specifications: Use only the fixing screws supplied with the product for installation. Use the correct length screws which are identified in the Installation Guide WARNING!Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. 8 Use The hood is designed to be used either for exhausting or filter version. Installation The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. Ducting version In this case the fumes are conveyed outside of the building by means of a special pipe connected with the connection ring located on top of the hood. Diameter of the exhausting pipe must be equal to that of the connection ring. In the horizontal runs the exhausting pipe must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. If the hood is supplied with active charcoal filter, then it must be removed. The models with no suction motor only operate in ducting mode, and must be connected to an external suction device (not supplied). The connecting instructions are supplied with the peripheral suction unit. 9 Operation Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. The signalling can be reset by carrying out the abovedescribed procedure twice. First it resets the grease filter signalling, then the carbon filter signalling. In case the filtering version hood is used, it is necessary to enable the carbon filter signalling. Activation of carbon filter signalling: Set the hood to OFF and keep keys “2” and “3” pressed contemporaneously for 3”. Deactivation of carbon filter signalling: Set the hood to OFF and keep keys “2” and “3” pressed contemporaneously for 3”. Temperature Alarm The hood is equipped with a temperature sensor which activates the motor at speed 3 in case the temperature in the display zone is too high. The alarm condition is indicated by the display with the letter t flashing. This condition remains as such until the temperature falls below the alarm threshold. This mode can be quit by pressing key “2”, “3” or “4”. [. . . ] Carbon filter signalling (only for filtering version) The carbon filter is signalled by the display with number 2 flashing after 160 hours of use. To eliminate the carbon filter signalling, press key “2” for more than 3”, until it turns off. In case both filters are signalled at the same time, numbers 1 and 2 flash on the display alternately. Speed 3 Speed 4 (intense) Grease filter maintenance Carbon filter maintenance Grease filter and carbon filter maintenance Temperature Alarm 10 Maintenance ATTENTION!Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. [. . . ]