User manual SMEG SAC578X

[. . . ] Since the machine can reach high temperatures while running, do not touch the drain hose and water during draining. In case of any failure, first unplug the device and close the water tap. Do not attempt to repair. Please apply to the nearest authorized service station. Do not forget that the packing material of your machine may be hazardous for children. [. . . ] As the amount of your clothes increases, the amount of the detergent to be consumed will also increase. Fill your softener in the softener compartment in your detergent drawer. Otherwise, the softener will diffuse in the washing water via the siphon. The softeners with high density should be diluted with some water before filling in the drawer. That is because the softener with high density obstructs the siphon and prevents the flow of the softener. 41 You can use fluid detergents in all programs without pre-washing. For this, mount the fluid detergent level plate in the second compartment of the detergent drawer and arrange the amount of fluid detergent according to the levels on this plate. RUNNING THE MACHINE Program selection and features Select the program and additional functions appropriate for your clothes from Table-1. Start/Pause By pressing this button, you can start the program you have selected or pause a running program. Run the program which you have selected by pressing the Start/Pause button. Changing the program If you have selected a program and you do not want if to continue: Press the start/pause button. Adjust the program knob to the program you desire. (You can select the program that you desire from Table-1). By pressing the start/pause button, run the program which you have selected. Remove the siphon plug and clean the residues of the softener thoroughly. Siphon plug THE CABINET Clean the exterior surface of the cabinet of your machine with lukewarm water and a cleaning substance that will not irritate the cabinet. If the machine is installed in a location where the ambient temperature can fall below 0 C, do the following when it will not be in use: Plug in the machine. Close the water tap and pull out the water inlet hose or hoses from the tap. Place the ends of the water drain and water inlet hoses in a cup on the ground. Unplug your machine when the program is over (program end light is on). When you complete these proces, the remaining water inside the machine will be drained and thus formation of ice in the machine will be prevented. When you operate your machine again, be sure that the ambient temperature is above 0 C. THE DRUM Do not leave metal parts like needles, staples or coins inside your machine. To eliminate these stains of rust, use a cleaning substance without chlorium and follow the warnings of the cleaning substance producer. For cleaning of the rust stains, never use dish-washing wires or similar rough objects. WARNING! REMOVE OF LIME FROM YOUR MACHINE If you arrange the amount of the detergent you use in your machine properly, there will be no need for lime removal. [. . . ] (*) Spread the clothes inside the machine in an orderly and wellbalanced manner. (**) Your machine is not draining water. Your machine is vibrating. (*)See the section concerning the maintenance and cleaning of your machine. (**)See the section concerning installations your machine. 51 FAILURE PROBABLE CAUSE There is a small amount of clothes in the device. Your machine is vibrating. Excessive amount of clothes are filled in the machine or the clothes are not placed in a well-balanced manner. Your machine touches a ripid object. Too much detergent has been used. [. . . ]