User manual SMEG SD7205SLD2P

[. . . ] • Make sure that the electrical information on the rating plate agrees with the power supply. • Make sure not to cause damage to the electrical components (e. g. Contact the Authorised Service Centre or an 17 electrician to change the electrical components. • Connect the mains plug to the mains socket only at the end of the installation. [. . . ] Timer indicator Shopping function Holiday function Temperature indicator Alarm indicator ChildLock function DrinksChill function G F E Switching on 1. To select a different set temperature refer to "Temperature regulation". If "dEMo" appears on the display, refer to "Troubleshooting" . Switching off 1. Disconnect the mains plug from the power socket. Temperature regulation Set the temperature of the appliance by pressing the temperature regulators. Default set temperature: • +5°C for the fridge The temperature indicators show the set temperature. 19 The set temperature will be reached within 24 hours. After a power failure the set temperature remains stored. Shopping function If you need to insert a large amount of warm food, for example after doing the grocery shopping, we suggest activating the Shopping function to chill the products more rapidly and to avoid warming the other food which is already in the refrigerator. The Shopping function shuts off automatically after approximately 6 hours. To switch off the function before its automatic end, repeat the procedure. The function switches off by selecting a different fridge set temperature. • a flashing Alarm indicator; • an acoustic buzzer. When normal conditions are restored (door closed), the alarm will stop. The buzzer can also be switched off by pressing any button. ChildLock function Activate the ChildLock function to lock the buttons from unintentional operation. • If the ambient temperature is high and the Temperature Regulator is set to low temperature and the appliance is fully loaded, the compressor may run continuously, causing frost or ice on the evaporator. If this happens, set the Temperature Regulator toward warmer settings to allow automatic defrosting and so a saving in electricity consumption. Hints for fresh food refrigeration To obtain the best performance: CARE AND CLEANING WARNING!This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. The accessories and parts of the appliance are not suitable for washing in a dishwasher. every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. Periodic cleaning CAUTION!Do not pull, move or damage any pipes and/or cables inside the cabinet. When moving the cabinet, lift it by the front edge to avoid scratching the floor. Clean the inside and accessories with lukewarm water and some neutral soap. Regularly check the door seals and wipe clean to ensure they are clean and free from debris. If accessible, clean the condenser and the compressor at the back of the appliance with a brush. [. . . ] Make sure that there is cold air circulation in the appliance. If the advice does not lead to the desired result, contact the nearest Authorised Service Centre. Closing the door 1. Contact the Authorised Service Centre. Replacing the lamp The appliance is equipped with a longlife LED interior light. Contact your Authorised Service Centre. INSTALLATION Positioning Install the appliance in a dry, well ventilated indoors where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance. Climate class SN N ST Ambient temperature Climate class T Ambient temperature +16°C to + 43°C +10°C to + 32°C +16°C to + 32°C +16°C to + 38°C 26 Some functional problems might occur for some types of models when operating outside of that range. The correct operation can only be guaranteed within the specified temperature range. [. . . ]