User manual SMEG SGR10S

[. . . ] Please read these operating instructions thoroughly before putting the device into operation so that you become familiar with its capabilities and can use its functions optimally. important notice: This device is a film rotary sealing device for closing sterile barrier systems. Please observe chapter "Correct use" in these operating instructions in this respect. [. . . ] 4 Sealing process sequence After the sterilisation packaging has been inserted the transport switches on automatically. The sterilisation packaging is now transported and the s ealing seam area is heated up by the heating dies positioned above and below to the sealing temperature set. The sealing seam, which is now heated up, is pressed through the sealing rolls and thus sealed. The completed sterilisation packaging is transported to the withdrawal side. If no further material to be sealed is fed in the transport switches off after approximately 30 seconds. 5 General safety information The device must not be installed and operated by persons under 14 years of age. Switch the device off or pull out the mains power plug when the device is not in use. Only use power outlets with a grounding conductor and a stable voltage supply. Heavy dust, steam, water drips or water spray compromise the function of the device. Please ensure that the operating voltage corresponds with the data on the device type plate. Please do not lift and transport the device at the sealing edge setting!1 Commissioning Temperature regulator Power connection Power switch Step 1: Step 2: Step 3: Step 4: Plug power cable into power connection. Set the desired sealing temperature on the temperature regulator as described in chapter 3. As soon as the set sealing temperature is displayed the device is heated up and ready for operation. [. . . ] Month According to load, at least once per year Key: Check Replace Page GB 10 9. F • • • • • • • Enter address, fax number and order number Enter serial number Enter device type Mark required items Enter required quantity Sign the order Fax the order 444444 SGR10S Page GB 11 9. _________________ Device type _________________ Date _______________ Serial number _______________ þ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ ¨ Signature Description Pressure roller Gear motor 230 V Heating element 115V 200W Fan 230V PTFE strip heating die PTFE strip guide die IEC cable feed with switch Fuse element for 6. [. . . ]