User manual SMEG SME3100ES

[. . . ] Follow the heating equipment manufacturer's guideline and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities. Always turn hood ON when cooking at high heat or when cooking flaming foods. Always use cookware appropriate for the size of the surface element. 1 CAUTION ! 1. [. . . ] For ductfree installation, remove louver cover from front (or inside) of hood. 3) NOTE Louvers on front of hood must be open and visible for hood to function in ductfree mode. Remove either top or rear electrical knockout depending upon whether wiring will enter hood from wall or cabinet. 4) DUCTED INSTALLATION ONLY NOTE Louver cover must be installed as shown in Figure 3 to function in ducted mode. Remove appropriate duct knockout on hood by inserting screwdriver into edge of knockout and breaking tabs holding knockout to hood. Fit damper/duct connector over opening and secure in place with black sheet metal screws. 6) Hinge pins and damper/duct connector should be toward top of hood for ducting through wall or toward back of hood for ducting through cabinet above hood. 7" round ducted discharge only: Re-install 7" round duct plate removed in Step #2 under "PREPARING THE RANGE HOOD" section. For best performance, line up the 7" round duct plate with the 7" round opening on hood. Mount duct plate to hood with 2 screws from duct plate and 2 screws from 3¼" x 10" damper. Damper flap must open freely in direction of air flow (away from range hood). FIG. Trim duct parallel to roof pitch, leaving 3/4" of duct projecting above roof. Seal around cap with roof cement and seal all nail heads and shingles which were cut or lifted. Make sure that enough duct runs into the room so that the duct will overlap the damper/duct connector by 3/4" when the hood is put into place. FIG. 8 3-1/4" x 10" DUCT FRONT OF CABINET HORIZONTAL DUCTING AND WIRING (Through Wall) 1-1/2" 3/8" 3-7/8" 1/8" 5-1/4" 5-1/4" 7-1/2" 3/4" CABINET BOTTOM 1-1/2" 6-7/8" 5-1/4" 9" 10-5/8" 7-1/2" 5-1/4" 9-7/8" VERTICAL DUCTING AND WIRING (Through Cabinet Bottom) BACK WALL 7" ROUND DUCT CABINET FRONT / FRENTE DEL GABINETE CABINET BOTTOM FONDO DEL GABINETE 8" DIA. ACCESS HOLE ORIFICIO DE ACCESO 8" DE DIÁ. 7½" 2" 5" ELECTRICAL ACCESS HOLE (in cabinet bottom) ORIFICIO DE ACCESO PARA LOS CABLES ELÉCTRICOS (en el fondo del gabinete) WOOD SHIMS (recessed-bottom cabinets only) CUÑAS DE MADERA (sólo gabinetes de fondo empotrado) FIG. 9 ROOF CAP WALL CAP 4 INSTALLING THE RANGE HOOD 16. Bring electrical cable through access hole drilled in wall or bottom of cabinet. Provide 6" wire leads and install proper connector for type of cable being used. Remove lock nut from connector and let prepared cable project through cabinet or wall opening so it is ready for installation into range hood. 10) 17. Position hood in place so that: a) Electrical line is routed through appropriate knockout opening. 13) b) Large part of keyhole mounting slots on hood fit onto hood mounting screws projecting from bottom of cabinet. 11) c) Damper/duct connector slides into duct work in wall or cabinet. [. . . ] DISCLAIMER OF IMPLIED WARRANTIES; LIMITATION OF REMEDIES CUSTOMER'S SOLE AND EXCLUSIVE REMEDY UNDER THIS LIMITED WARRANTY SHALL BE PRODUCT REPAIR OR REPLACEMENT AS PROVIDED HEREIN. CLAIMS BASED ON IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO ONE YEAR OR THE SHORTEST PERIOD ALLOWED BY LAW, BUT NOT LESS THAN ONE YEAR. ELECTROLUX SHALL NOT BE LIABLE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SUCH AS PROPERTY DAMAGE AND INCIDENTAL EXPENSES RESULTING FROM ANY BREACH OF THIS WRITTEN LIMITED WARRANTY OR ANY IMPLIED WARRANTY. SOME STATES AND PROVINCES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, OR LIMITATIONS ON THE DURATION OF IMPLIED WARRANTIES, SO THESE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. [. . . ]