User manual SMEG SPR876AVOGH

[. . . ] The temperature inside the There could be various causes compartments is not low (see “Solutions”). enough. There is water on the bottom of the refrigerator compartment. One or more green lights flash continuously. Make sure: - the doors close properly - the appliance is not installed near a heat source - the set temperature is adequate - the circulation of air through the vents at the bottom of the appliance is not obstructed. hole (see the section “Appliance Maintenance and Cleaning”). [. . . ] In this case, disable the function temporarily. To ensure correct operation of the product, adequate preservation of food and to optimise energy consumption, it is advisable not to remove the Meat & Fish compartment if the symbol (see Quick Guide) is not present on the control panel. In all other cases, the Meat & Fish compartment can be removed to obtain more space inside the refrigerator. Remove the drawer cover by releasing the bottom side clips (Figure 2). To reinstate the Meat & Fish compartment, make sure to refit the drawer cover before inserting the drawer and reactivating operation. Press the “Meat & Fish compartment function” button on the control panel for 3 seconds, until the yellow indicator goes off. To optimise energy consumption, it is advisable to deactivate the Meat & Fish compartment and remove its components (except the shelf above the crisper drawers). Removing the Meat & Fish compartment: Fig. 2 13 “ZERO DEGREES” BOX (depending on the model) The “Zero Degrees” box is specifically designed to maintain a low temperature and a suitable humidity level, in order to keep foods fresher for longer (e. g. meat, fish, fruit and winter vegetables). Activating and deactivating the box To activate the compartment, press the button shown in the figure for more than 1 second, until the symbol lights up The temperature inside the box, when active, is approximately 0°. The symbol lit indicates that the compartment is functioning. Press the button again for more than 1 second to deactivate the compartment The following factors are vital for the “Zero Degrees” box to work properly: - the refrigerator compartment must be switched on - the temperature of the refrigerator compartment must be between +2°C and +6°C - the box must be inserted to enable activation - no special functions must have been selected (Standby, Cooling-Off, Vacation – where applicable). If one of these special functions has been selected, the “Zero Degrees” box must be deactivated manually, and any fresh food inside it removed. If manual deactivation does not take place, the box will be deactivated automatically after 8 hours. the compartment • Do not use sharp or pointed instruments to detach the tray if it is stuck to the bottom of compartment. 2 16 How to defrost the appliance Before defrosting the appliance, unplug it or switch off the power at the mains. Droplets of water on the rear wall of the refrigerator compartment indicate that the periodic automatic defrost cycle is in progress. The defrost water is automatically routed to a drain outlet and into a container from which it evaporates. Clean the defrost water drain outlet regularly using the tool supplied with the appliance in order to ensure defrost water is removed correctly. 1) Defrosting the compartment (if present) Defrost the compartment once or twice a year or when ice formation is excessive. The amount of ice which forms and the rate at which it accumulates will vary depending on ambient conditions and the frequency with which the freezer door is opened. Ice formation is concentrated at the top of the compartment and does not affect the efficiency of the appliance. • Remove the food from the freezer compartment and group together in a cool place or in a cool bag. • Clean the interior of the freezer with a sponge and warm water and/or neutral detergent. Plug the appliance back in and switch on, following the instructions in chapter “How to operate the refrigerator compartment”. [. . . ] The manufacturer declines all liability for injury to persons or animals and for damage to property resulting from failure to observe the above procedures and reminders. • If the plug and socket are not of the same type, have the socket replaced by a qualified electrician. Disconnecting the appliance It must be possible to disconnect the appliance by unplugging it or by means of a two-pole switch fitted upline of the socket. 19 ELECTRICAL CONNECTION FOR GREAT BRITAIN AND IRELAND ONLY Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A. S. T. A. approved fuse to BS 1362 type and proceed as follows: 1. Remove the fuse cover (A) and fuse (B). [. . . ]