User manual SMEG SWE108D

[. . . ] The equipment must be earthed in accordance with the safety regulations of the electrical system. The plug to be connected to the power cable must be compliant with the regulations in force. Use the hood at an ambient temperature between +5 °C and +35 °C. [. . . ] Use the hood at an ambient temperature between +5 °C and +35 °C. This appliance is intended for professional use and complies with the EC directives in force. The appliance functions as a condenser for the exhaust vapours of the oven, therefore any other use of the device is improper. The Manufacturer refuses all responsibility for direct and indirect damage caused by improper installation, tampering with, inadequate maintenance, improper use and failure to comply with the regulations contained in the instruction manual. 1. Instructions The following instruction manual is an integral part of the equipment and must be at the operators’ disposal for advice until the end of the life cycle of the product. Before carrying out any operations, carefully read the information contained in the manual about safe installation, use and maintenance. The equipment is only intended for the use it has been designed for, by qualified and skilled personnel. After removing the front cover to which is attached the fan you can proceed to remove the screws that fixed the fan to the front cover. 3. 3 – Disassembling the switch ON OFF Before removing the switch must be removed the cover panel mounted on the oven hood, fixed by screws (Fig. – Before closing back the connections, make sure that the electronic card has been replaced without inverting the order of the temperature feelers. 3. 5 Spare parts It is possible to use original or authorized spare parts only. Do not repair or replace any components of the oven hood that have not been recommended by this manual. – When removing the panels, handle them with great attention by using gloves to protect hands from possible cuts. out by authorized technical personnel. To ask for a spare part, indicate the hood model specified on the label. [. . . ] Do not repair or replace any components of the oven hood that have not been recommended by this manual. – When removing the panels, handle them with great attention by using gloves to protect hands from possible cuts. out by authorized technical personnel. To ask for a spare part, indicate the hood model specified on the label. [. . . ]