User manual SMEG SX91M-1

[. . . ] THIS APPLIANCE IS INTENDED FOR DOMESTIC USES AND CONFORMS TO CURRENT REGULATIONS IN FORCE. THE APPLIANCE HAS BEEN BUILT TO CARRY OUT THE FOLLOWING FUNCTIONS: COOKING AND HEATING-UP OF FOOD. SEPARATE THE VARIOUS WASTE MATERIALS AND TAKE THEM TO THE NEAREST SPECIAL GARBAGE COLLECTION CENTRE. IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE GROUNDED ACCORDING TO THE METHODS REQUIRED BY SAFETY RULES. WHEN LINKING UP TO MAINS BY PLUG AND SOCKET, MAKE SURE THAT BOTH ARE COMPATIBLE AND CONNECT BY MEANS OF A POWER CABLE COMPLYING WITH APPLICABLE REGULATIONS. IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE APPLIANCE, FOLLOWING THE INSTRUCTIONS BELOW. [. . . ] The supplied reduction rest C is also used for small pans. The drawing next to each knob shows the corresponding burner. Simply press and turn the knob anticlockwise to the minimum flame symbol , until the ring is lit. If it does not light within the first 15 seconds, turn the knob to 0 and wait at least 60 seconds before trying to light the burner again. Hold the knob down for a few seconds to allow the thermocouples to heat up. The burner may go out when the knob is released: this is because the thermocouple has not been sufficiently heated. For models with thermocouples, if the burner should accidentally go out, a safety device will be activated which stops the gas flow even if the tap is open. In this case, turn the knob back to the off position and wait at least 60 seconds before trying to relight the burner. 6. 2 Practical advice for using the cooking hob burners For better use of the burners and lower gas consumption, use covered containers that are proportional in size to the burner to prevent the flame from licking the sides (see paragraph "6. 3/6. 4 Diameter of containers"). When water reaches the boiling point, lower the flame so that it doesn't overflow. To avoid burns or damage to the hob, all recipients or griddle plates must be placed within the perimeter of the cooking hob. When using fats or oils, be extremely careful that they don't overheat and catch fire. If the flame accidentally goes out, turn off the control knob and wait at least 1 minute before trying to re-light the burner. 18 Instruction for the user 6. 3 Diameter of containers (60 cm models) BURNERS (60 X 50) 1. Fans cause a steady outflow of air from above the door which may continue for a brief period of time even after the oven has been turned off. 7. 3 Use of the gas oven 7. 3. 1 Electronic spark lighting Open the oven door completely, press the thermostat knob and turn it clockwise to max. Once the oven is lit, hold the knob down for a few seconds to allow the thermocouple to heat up. This device should not be enabled for more than 15 seconds; if after this time the burner has not come on, stop, fully open the oven door and try again after one minute. 7. 3. 2 Manual lighting Open the oven door completely and turn the thermostat knob. Place a lit match to the mouth of the flame pipe A in the centre of the oven floor and press the thermostat knob. Once the oven is lit, hold the knob down for a few seconds to allow the thermocouple to heat up and check that the oven is lit through the inspection hole B. Choose the cooking temperature by turning the knob clockwise to the desired temperature, between 50° and 275°C. If the burner is accidentally switched off, turn the knob to the off position ( before lighting again. ) and wait for one minute 21 Instruction for the user 7. 4 7. 4. 1 Use of the electric grill Using the grill in cookers with electric oven For short cooking procedures, such as the final crisping of meat which is already cooked, select the and turn the thermostat knob to the maximum temperature. The fan grill static grill function function (certain models only) allows actual cooking procedures to be carried out, thanks to the fan function which ensures that the heat penetrates into the food. For this cooking mode, select the fan grill function than 200° C). [. . . ] 9. 1. 3 Deactivating the acoustic device The acoustic device stops sounding automatically after seven minutes. 9. 1. 4 Adjusting the volume of the acoustic device key. The volume can be adjusted (3 settings) while it is in operation by pressing the 9. 1. 5 Modifying the data set or keys. The timer data set can be modified at any moment by pressing the 10 ANALOGUE CLOCK (ONLY ON EQUIPPED MODELS) The mechanical timer is set by turning the knob clockwise. At the end of the cooking time, an alarm signal will be heard: to stop the alarm turn the external part of the knob to position . The clock is set by pulling the knob and turning it clockwise. 27 Instruction for the user 11 CLEANING AND MAINTENANCE 11. 1 Cleaning stainless steel and enamelled versions To maintain stainless steel in good condition it must be cleaned regularly after each use, once it has cooled down. 11. 1. 1 Ordinary Daily Cleaning To clean and preserve the stainless steel surfaces, always use only specific products that do not contain abrasives or chlorine-based acids. [. . . ]