User manual SMEG SX91VJME9

[. . . ] • Never try to put out a fire or flames with water: Turn off the appliance and smother the flames with a fire blanket or other appropriate cover. • Have qualified personnel carry out installation and assistance interventions according to the standards in force. • Do not modify this appliance. • Do not insert pointed metal objects (cutlery or utensils) into the slots in the appliance. • Do not try to repair the appliance yourself or without the intervention of a qualified technician. [. . . ] All the appliance’s control and monitoring devices are located together on the front panel. Simply press the knob and turn it anticlockwise to the maximum flame symbol, until the burner lights. If the burner does not light in the first 15 seconds, turn the knob to and wait 60 seconds before trying again. After lighting, keep the knob pressed in for a few seconds to allow the thermocouple to heat up. The burner may go out when the knob is released: In this case, the thermocouple has not heated up sufficiently. In case of an accidental switching off, a safety device will be tripped, cutting off the gas supply, even if the gas cock is open. Return the knob to and wait at least 60 seconds before lighting it again. 3. 4 Using the storage compartment The storage compartment is at the bottom of the cooker. After connecting the device to the mains, do one of the following ways: • Turn the functions knob or minute timer knob (depending on model) to lamp position to switch on the appliance interior lighting. Check the leakage of air from the slits placed on the back of the hob. 4. After lighting, keep the knob pressed down for a few seconds to allow the thermocouple to heat up. In case of accidental extinguishing, turn the knob to the off position and do not try to light the burner again for at least 60 seconds. 17 EN Manual ignition: Presence of electrical voltage Use Using the gas grill Electronic spark ignition: 1. This is a completely natural phenomenon which has no effect on the operation of this component. Cleaning the igniters and thermocouples • If necessary, clean the igniters and thermocouples with a damp cloth. 4. 1 Instructions Improper use Risk of damage to surfaces • Do not use steam jets to clean the appliance. • Do not use cleaning products containing chlorine, ammonia or bleach on steel parts or parts with metallic finishes on the surface (e. g. scouring powders, stain removers and metallic sponges) on glass parts. • Do not use rough or abrasive materials or sharp metal scrapers. • Do not wash the removable components such as the hob grids, flame-spreader crowns and burner caps in a dishwasher. 4. 2 Cleaning the appliance We recommend the use of cleaning products distributed by the manufacturer. Recommendations for cleaning the hob To keep the surfaces in good condition, they should be cleaned regularly after use. Let them cool first. 21 EN 4 Cleaning and maintenance Cleaning the hob Cleaning and maintenance • If there is any dry residue, remove it with a toothpick or needle. Cleaning the glass lid For easier cleaning, the lid can be taken off its hinges. Unscrew the screws on the back of the hinges (A). Cleaning the oven In order to keep your oven in the best possible condition, clean it regularly after letting it cool down. Avoid letting food residue dry inside the oven compartment, as this could damage the enamel. [. . . ] When changing the type of gas supply, the minimum must be adjusted as follows: 1. Light the oven burner and run it at full power for 10-15 minutes with the door closed and without the base. Slide off the knob and insert a straight edge screwdriver to make the adjustment. If using liquid gas the adjustment screw must be tightened clockwise to the very end. [. . . ]