User manual SMEG UD7122CSP

[. . . ] • Make sure that the electrical information on the rating plate agrees with the power supply. • Make sure not to cause damage to the electrical components (e. g. Contact the Authorised Service Centre or an 17 electrician to change the electrical components. • Connect the mains plug to the mains socket only at the end of the installation. [. . . ] • Remove the door to prevent children and pets to be closed inside of the appliance. • The refrigerant circuit and the insulation materials of this appliance are ozonefriendly. Contact your municipal authority for information on how to discard the appliance correctly. • Do not cause damage to the part of the cooling unit that is near the heat exchanger. 18 OPERATION Switching on 1. Turn the Temperature regulator toward lower settings to obtain the minimum coldness. Turn the Temperature regulator toward higher settings to obtain the maximum coldness. If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Switching off To turn off the appliance, turn the temperature regulator to the "O" position. Temperature regulation The temperature is regulated automatically. However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: • room temperature, • how often the door is opened, • the quantity of food stored, • the location of the appliance. FIRST USE Cleaning the interior Before using the appliance for the first time, the interior and all internal accessories should be washed with lukewarm water and some neutral soap to remove the typical smell of a brand-new product, then dried thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. DAILY USE WARNING!However, for a faster freezing operation, turn the temperature regulator toward higher settings to obtain the maximum coldness. When moving the cabinet, lift it by the front edge to avoid scratching the floor. Clean the inside and accessories with lukewarm water and some neutral soap. Regularly check the door seals and wipe clean to ensure they are clean and free from debris. If accessible, clean the condenser and the compressor at the back of the appliance with a brush. This operation will improve the performance of the appliance and save electricity consumption. General warnings CAUTION!This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. After three hours reload the previously removed food into the freezer compartment. Cleaning the air channels 1. Remove the plinth (A), then the ventilation grid (B). C B A 2. Carefully pull the air deflector out (C), checking that there is no water left from the defrosting. Clean the lower part of the appliance with a vacuum cleaner. 23 Periods of non-operation When the appliance is not in use for long periods, take the following precautions: 1. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. TROUBLESHOOTING WARNING! [. . . ] Replace the used lamp with a new lamp of the same power and specifically designed for household appliances (the maximum power is shown on the lamp cover). Some functional problems might occur for some types of models when operating outside of that range. The correct operation can only be guaranteed within the specified temperature range. If you have any doubts regarding where to install the appliance, please turn to the vendor, to our customer service or to the nearest Authorised Service Centre. Location Refer to the assembly instructions for the installation. [. . . ]