User manual SMEG UKUD7122CSP

[. . . ] • Make sure that the electrical information on the rating plate agrees with the power supply. • Make sure not to cause damage to the electrical components (e. g. Contact the Authorised Service Centre or an 4 electrician to change the electrical components. • Connect the mains plug to the mains socket only at the end of the installation. [. . . ] • Do not cause damage to the part of the cooling unit that is near the heat exchanger. 5 OPERATION Switching on 1. Turn the Temperature regulator toward lower settings to obtain the minimum coldness. Turn the Temperature regulator toward higher settings to obtain the maximum coldness. If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Switching off To turn off the appliance, turn the temperature regulator to the "O" position. Temperature regulation The temperature is regulated automatically. However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: • room temperature, • how often the door is opened, • the quantity of food stored, • the location of the appliance. FIRST USE Cleaning the interior Before using the appliance for the first time, the interior and all internal accessories should be washed with lukewarm water and some neutral soap to remove the typical smell of a brand-new product, then dried thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. DAILY USE WARNING!However, for a faster freezing operation, turn the temperature regulator toward higher settings to obtain the maximum coldness. In this condition, the refrigerator compartment temperature might drop below 0°C. If this occurs reset the temperature regulator to a warmer setting. Freezing fresh food The freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time. To freeze fresh foods it is not necessary to change the medium setting. 6 Storage of frozen food When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run at least 2 hours on the higher settings. The accessories and parts of the appliance are not suitable for washing in a dishwasher. Periodic cleaning CAUTION!Do not pull, move or damage any pipes and/or cables inside the cabinet. When moving the cabinet, lift it by the front edge to avoid scratching the floor. Clean the inside and accessories with lukewarm water and some neutral soap. Regularly check the door seals and wipe clean to ensure they are clean and free from debris. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. Cleaning the air channels 1. Remove the plinth (A), then the ventilation grid (B). TROUBLESHOOTING WARNING!Refer to Safety chapters. 10 What to do if. . . Problem The appliance does not operate. The lamp is defective. The compressor operates continually. Temperature is set incorrectly. Food products placed in the appliance were too warm. There is too much frost and ice. The door is not closed correctly or the gasket is deformed/dirty. Temperature is set incorrectly. Position the water drainage plug in the correct way. [. . . ] The correct operation can only be guaranteed within the specified temperature range. If you have any doubts regarding where to install the appliance, please turn to the vendor, to our customer service or to the nearest Authorised Service Centre. • A - green and yellow: Earth • C - brown: Live • D - blue: Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yellow to the terminal marked either with the letter “E“ or by the earth 13 symbol or coloured green and yellow. Connect the wire coloured blue to the terminal either marked with the letter “N“ or coloured black. [. . . ]