User manual SMEG WMI14C7

[. . . ] Consignment to the appropriate facility for environmentally responsible recycling, treatment and disposal helps to prevent any negative effects on the environment and health, and encourages the reuse and/or recycling of the appliance’s component materials. Illegal dumping of the appliance by the user will be subject to prosecution under the relevant law. 1 EN READ THE INSTRUCTIONS Attention!You are advised to read all the instructions in this manual carefully; it will inform you about the right conditions for the proper, safe use of your washing machine. It is very important to keep this instruction manual with the appliance for future reference. [. . . ] • If the washing programme is interrupted, it will be from 3 to 15 minutes before the door can be opened, depending on the temperature reached inside the appliance. The water may still be boiling hot if the wash was at high temperature. Do not open the door if there is still water in the drum! 4. 3 LOADS OF WASHING As far as possible, to save electricity, it is more economical to wash complete loads of the various types of fabric. Shake out the washing before loading, and alternate large and small items. It is best to weight the load the first few times, after which you will be able to rely on your experience. As a guide, the following is a list of the average weights of the standard items: 9 EN 4. 4 LOADING THE ITEMS FOR WASHING 1. Open the door and load the washing, distributing it evenly over the drum, with items opened out and not bundled together; if possible, large and small items should be well mixed. The washing machine covered by this manual can be loaded with up to 7kg of washing for each wash. If this weight is exceeded, the washing results will be poor and the appliance may malfunction. To save energy it is more economical to wash full loads of the various types of fabric, following the guidance on quantities provided in the “Programmes Table” supplied in this manual. Close the door by pressing against the frame until you hear it click shut. Place the detergent in the compartments first, followed by the descaler. 4. 9 PROGRAMMES AND FUNCTIONS For advice on selecting programmes in relation to the type of fabric, refer to the "Programmes Table", supplied with this manual. 4. 10 SWITCHING ON THE APPLIANCE AND SELECTING THE WASHING PROGRAMME To switch on the appliance and select the programme, proceed as follows: 1. The symbols on the display light up to identify the information shown. The initial settings can be modified using the button underneath the sequence of spin speeds. If spin speed is set, there will be no spin cycle and the appliance will stop with the tank full. If this value is set the appliance does not perform the final spin and the washing programme ends with water in the tank. Time to end Spin Speed selection 11 EN 4. 11 SELECTING AND CONFIRMING OPTIONS Options Option selection 1. Confirm option Start Pause The Option Selection button can be used to select the following options in sequence (from the top down): Prewash: adds a stage before the main wash, lasting about 20 minutes at a temperature of 35°C. temperature is changed to 60°C and the washing stage is extended to increase the effectiveness of the enzymes in the detergents. Water plus: Increases the amount of water used for washing and rinses. In alternative Extra rinse: this option adds a rinse to the selected washing programme. Buzzer: sets whether or not the buzzer will sound at the end of the cycle. To confirm the selected option, simply press the Confirm options button and the LED of the option remains on. To delete an option selection, simply return to the option with the Selection button and press the Confirm options button. [. . . ] Should you wish to use the magnetic lock instead of the pushpull lock, remove the push-pull lock support and fit the supplied magnetic lock support. Before fitting the panel (removing all the hinge and locking elements from the front) make sure the washing machine is totally disconnected from the mains power supply. Warning - To fix the panel on the right-hand side (direction of opening opposite to that of the door) dismount the push-pull lock (or the magnet lock) from the front of the machine and the rubber pad (fig. All the elements applied to the front of the washing machine must be remounted correctly (no holes must remain open) in order to make it impossible to touch live components inside the machine. [. . . ]