User manual SONY HCD-EP313

[. . . ] 4-246-166-11(2) Micro Hi-Fi Component System Operating Instructions Owner's Record The model and serial numbers are located at the rear. Refer to them whenever you call upon your Sony dealer regarding this product. Serial No. CMT-EP313 ©2003 Sony Corporation WARNING WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. To prevent fire, do not cover the ventilation of the apparatus with news papers, table-cloths, curtains, etc. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the apparatus. [. . . ] To start from a specific track, make a program (see "Creating your own program" on page 7). · TUNER: Tune in a radio station (see "Listening to the radio" on page 9). Timer 2 3 4 Press VOL +/­ repeatedly (or turn VOLUME on the unit) to adjust the volume. Press CLOCK/TIMER SET repeatedly until "ON" and "0:00" appear. Set the time to start playback. Press . /> repeatedly to set the hour, then press CLOCK/TIMER SET. Press . /> repeatedly to set the minute, then press CLOCK/TIMER SET. 5 6 7 Press CLOCK/TIMER SET repeatedly until "OFF" and "0:00" appear. Press . /> depending on the sound source you want to play. Each time you press the button, the display changes as follows: Tu y Cd 8 To Press ?/1 to turn off the system. Other operations Do this Press CLOCK/TIMER SELECT repeatedly. Cancel the timer Press CLOCK/TIMER SELECT repeatedly until "OFF" appears, then press CLOCK/TIMER SET. Check the setting 13GB Display Turning off the display -- Power Saving Mode The clock display can be turned off to minimize the amount of power consumed during standby (Power Saving Mode). Press DISPLAY. Viewing information about the disc in the display You can check the playing time and remaining time of the current track or that of the disc. Checking the remaining time (CD) Press DISPLAY repeatedly during CD playback. To cancel Power Saving Mode Press DISPLAY. Tips · The STANDBY indicator lights up even in the Power Saving Mode. · The timer continues to operate in Power Saving Mode. Each time you press the button, the display changes cyclically as follows: Elapsed playing time on the current track t Remaining time on the current track* t Remaining time on the current disc** * "­ ­:­ ­" appears when a track is played whose number is 31 or over. **"­ ­:­ ­" appears when the total playing time of the program exceeds 100 minutes, when the program contains 31 tracks or more, or when a disc with 31 tracks or more is played in Shuffle Play mode. 14GB Optional Components Hooking up optional components To enhance your system, you can connect optional components. Refer to the operating instructions provided with each component. Optional analog component From the audio output jacks of an optional analog component Optional Components A MD IN jacks Use audio cords (not supplied) to connect an optional analog component (MD deck, etc. ) to these jacks. You can then listen to the sound from the component. Recording audio from a connected component 1 Connect audio cords. 2 Start recording manually. See "Recording on a tape manually" on page 11. Listening to audio from a connected component 1 Connect audio cords. See "Hooking up optional components" on page 15. 2 Press MD. Start playing the connected component. 15GB Troubleshooting Problems and remedies Should you encounter a problem with your system, do the following: There is severe hum or noise. · Install a noise filter (commercially available) to the power line. · Turn off the TV set once, then turn it on after 15 to 30 minutes. If the color irregularity still persists, place the speakers farther away from the TV set. 1 Make sure the power cord and speaker cords are correctly and firmly connected. 2 Find your problem in the troubleshooting checklist below and take the indicated corrective action. If the problem persists after doing all of the above, consult your nearest Sony dealer. General The display or button remains lighted or flashes even after the system was turned off. · The power cord is disconnected or a power failure occurs longer than half a day. Redo the following: ­ "Setting the clock" (page 5) ­ "Presetting radio stations" (page 8) If you have set the timer, also redo "Waking up to music" (page 13). · Press VOL + repeatedly (or turn VOLUME on the unit clockwise). · Insert only the stripped portion of the speaker cord into the SPEAKER terminal. Inserting the vinyl portion of the speaker cord will obstruct the speaker connections (page 4). · Check that the speaker's + and ­ terminals are connected correctly. CD player The CD compartment does not close. [. . . ] Be sure to check that the label side of the disc is not sticky before using. The following types of disc should not be used: ­ Rental or used discs with attached seals where the glue extends beyond the seal. ­ Discs that have labels printed using a special ink that feels tacky when touched. · Discs with non-standard shapes (e. g. , heart, square, star) cannot be played on this unit. [. . . ]