User manual SONY ICF-PRO80

[. . . ] ⷠThe unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. ⷠDo not leave the unit in a location near a heat source such as a radiator or airduct, or in a place subject to direct sunlight, excessive dust, mechanical vibration, or shock. ⷠAllow adequate air circulation to prevent internal heat build-up. ) or near materials (a curtain) which might block the ventilation holes. [. . . ] ) or near materials (a curtain) which might block the ventilation holes. ⷠShould any solid object or liquid fall into the unit, unplug the unit and have it checked by a qualified personnel before operating it any further. ⷠTo clean the casing, use a soft cloth dampened with a mild detergent solution. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. Two short beeps sound when the minimum frequency of each band is received during tuning. While holding down OFF, keep pressing PRESET 1 for more than 5 seconds. When the AM channel step is changed, the preset stations will be erased. ⷠWhen the AM channel step is changed, the FM channel step is also changed. AM: When installing the unit, rotate the unit horizontally for optimum reception and then install the unit. The display shows the band and frequency for a few seconds and then changes back to the current time. Before setting the alarm, make sure to set the clock (see "Setting the Clock"). ⷠTo reduce the risk of fire, do not place any heating or cooking appliance beneath this unit. ⷠInstall the unit so that its AC power cord can be connected directly to a wall outlet. Be sure that the AC power cord has no slack when using the unit, since the cord acts as an FM wire antenna. If the AC power cord has some slack, wind it up to the cord hook until the cord has no slack. ⷠInstall the unit as far as possible from a source of noise. (for example , refrigerator , microwave oven , fluorescent lamp , etc. If you press CD u when there is no disc in the CD compartment, "00" flashes for about 5 seconds on the display and the unit turns off automatically. Each press changes the play mode as follows: When TUNE/TRACK/TIME SET + or ­ is held down, the displayed time initially changes in one-minute steps, and after about a second, switches to ten-minute steps. The display shows the alarm time for a few seconds and then returns to show the current time. [. . . ] If you press CD u when there is no disc in the CD compartment, "00" flashes for about 5 seconds on the display and the unit turns off automatically. Each press changes the play mode as follows: When TUNE/TRACK/TIME SET + or ­ is held down, the displayed time initially changes in one-minute steps, and after about a second, switches to ten-minute steps. The display shows the alarm time for a few seconds and then returns to show the current time. Press TUNE/TRACK/TIME SET + or ­ until the correct hour appears in the display. [. . . ]