User manual SONY MHC-1200

[. . . ] ­ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] However, if a CD is used in a program, play does not start even if you press CD 1 ­ 3. Disc tray number Total playing time (including selected track) Remove a CD Exchange other CDs while playing Play repeatedly (Repeat Play) To cancel playing repeatedly, press REPEAT until "REP" or "REP 1" disappears. ** When you select "REP 1", that track is repeated endlessly until "REP 1" is canceled. Other discs Other tracks on the same disc Other tracks on other discs The play mode cannot be changed while playing a disc. You can make a program of up to 32 tracks from all the CDs in the order you want to play them. Cancel Program Play Clear a track from the end Clear the entire program Press x once in stop mode or twice during play. To play the same program again, press CD, then press H (or N on the remote). --" appears when the total CD program time exceeds 100 minutes, or when you select a CD track whose number is 21 or over. Or + on the remote) until the frequency indication starts to change, then release it. You can check the remaining time of the current track or the entire CD. During normal play Scanning stops automatically when the system tunes in a station. Each time you press the button, the minute display (the turn-off time) changes cyclically as follows: AUTO* t 90 MIN t 80 MIN t 70 MIN t . t 10 MIN t OFF * The system turns off when the current CD or tape finishes playback (for up to 100 minutes). The type of timer ("DAILY"), followed by the start time, stop time, and the music source, appear, then the original display appears. Connect the video output of the video game machine to the VIDEO jack, and the audio output to the AUDIO jacks on the front panel of the system. connect the VIDEO OUT jack on the rear panel of the system to the video input of a TV using the optional video cable. To listen to the sound of the connected video game machine, press GAME. When you use the Sleep Timer, the Daily Timer will not turn on the system until the Sleep Timer turns it off. Before operating the system, check that the operating voltage of your system is identical with the voltage of your local power supply. The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. ⷠUnplug the system from the wall outlet (mains) if it is not to be used for an extended period of time. Should any solid object or liquid fall into the component, unplug the system and have it checked by qualified personnel before operating it any further. [. . . ] Be sure to clean the tape heads before you start an important recording or after playing an old tape. Discs recorded on CD-R drives may not be played back because of scratches, dirt, recording condition or the drive's characteristics. Besides, the discs, which are not yet finalized at the end of recording, cannot be played back. Demagnetize the tape heads and the metal parts that have contact with the tape every 20 to 30 hours of use with a separately sold demagnetizing cassette. [. . . ]