User manual SONY TA-AX520 schematic

[. . . ] Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. Before operating the amplifier, please read this manual thoroughly and retain it for future reference. The instructions in this manual are for models TA-FB930R and TA-AX520. [. . . ] Check your model number by looking at the rear panel of your amplifier. The TA-FB930R is the model used for illustration purposes unless stated otherwise. Any difference in operation is clearly indicated in the text, for example, "TA-FB930R only. The following icon is used in this manual: Check that you have received the following supplied items: · Insert two R6 (size-AA) batteries, matching the + and ­ on the batteries with the markings inside the battery compartment. When the remote no longer operates the amplifier, replace all the batteries. ⷠDo not drop any foreign object into the remote casing, particularly when replacing the batteries. ⷠIf you don't use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion. The amplifier allows you to connect and control the following audio components. Follow the hookup procedure indicated for each component that you want to connect. To learn the location and name of each jack, see "Rear Panel Descriptions" on page 11. Adjust the bass Adjust the treble Adjust the balance Reinforce the bass and treble at low listening level Reduce subsonic noise components created by warped records, etc. This allows the unit to automatically switch to a programme type of your choice when one starts in your broadcast area. When your amplifier is connected to a Sony tuner with the EON CONTROL system, the amplifier switches to any EON programme that is broadcast in your EON area, and switches back to the last selected programme source when the programme ends. Make sure that the amplifier and the tuner are connected through the EON CONTROL terminals (see page 5). Whenever an EON programme starts on the radio frequency that your tuner is set to, you will receive it. If you select another programme source while receiving an EON programme, EON reception ends. However, as long as the EON LINK indicator lights up, you can receive EON programmes automatically. ⷠMake sure to cancel EON reception before starting to record since an EON programme may interfere with your recording. ⷠIf you activate the Tape Monitor function (see page 9) while the EON LINK indicator is lit, the indicator goes off and you cannot receive EON programmes. If this happens, deactivate the Tape Monitor function so that the indicator lights up again. [. . . ] If this happens, deactivate the Tape Monitor function so that the indicator lights up again. You can record the same source on two recording components at the same time You can monitor the recorded sound (Tape Monitor function) You can monitor the recorded sound if the tape deck you are recording on has separate playback and recording heads. Note that on the TA-AX520, you can monitor the only sound being recorded from the TAPE1/DAT jacks. Before you begin recording, press the EON LINK button to turn off the EON LINK indicator (see page 8). [. . . ]