User manual SONY TA-F222ESA service manual

[. . . ] Install this system so that the power cord can be unplugged from the wall socket immediately in the event of trouble. Don't throw away the battery with general house waste, dispose of it correctly as chemical waste. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. [. . . ] When you play back a DTS 96/24 format disc, set the DIRECT function to ON. When you connect headphones, the DTS 96/24 signal is played back at DTS 48 kHz. Connects to a Super Audio CD player, tape deck, MD deck or DAT player, etc (page 7). Set the appropriate speaker impedance for the speakers you are using (page 5). COAXIAL IN Connects to a DVD jacks player, Super Audio CD player, etc. The COAXIAL jacks OPTICAL IN/ provide a better OUT jack quality sound (page 8). Both the left and the right balance can be adjusted from 0 dB to +20 dB. H SLEEP Press to activate the Sleep Timer function and the duration which the amplifier turns off automatically. When you play back a DTS 96/24 format disc, set the DIRECT function to ON. Remove any obstacles from the measurement area to avoid measurement error. The auto calibration function does not work when headphones are connected to the amplifier. You may be able to perform the auto calibration properly if you try it again, even though the measurement cannot be performed in all environments. Appears to ask you to re-measure or exit without re-measuring when the measurement fails. CANCEL Appears when you cancel auto calibration during the measurement. * TSP (Time Stretched Pulse) A TSP signal is a highly precise measuring signal that utilizes impulse energy, measuring a wide band, from low to high, in a short period. the amount of energy used to measure signals is important to ensure measurement accuracy in a normal indoor environment. By using the System Settings menus, you can make various adjustments to customize the amplifier. Press U to display "<1-System Settings>, " then press ENTER to enter the menu. After the measurement is completed, this setting is set to ON automatically. DTS 96/24 signals are played back as 48 kHz signals when EQ CURVE EFFECT is set to "ON. " When you play back DTS 96/24 signals, set this item to "OFF" and set the DIRECT function to "ON" (page 10, 12). You cannot select this setting before saving the measurement results (factory setting). [. . . ] If you are not going to use the amplifier for a long time, be sure to disconnect the amplifier from the wall outlet. If both channels are output from the headphones, the speaker may not be connected to the amplifier correctly. Check the connection of the speaker which is not outputting any sound. Make sure you have connected both the L or R jack to an analog component and not just to either the L or R jack. [. . . ]