User manual STRONG 5-IN-1 REMOTE

[. . . ] Look for the brand name of the device you wish to control in the attached CODE LIST at the end of this user-manual (e. g. Next to the brand name you will find one or more 3-digit code numbers (e. g. SONY: 028) which have to be entered in the following way: Press and hold both the key and the appropriate device key , , , , on the remote until the LED turns ON and then release both keys. [. . . ] Press the key again, and then the LED should start blinking which means your remote is in code search mode. Continue pressing this button slowly with intervals of about 2 seconds between each press until the device is switched OFF. Your remote control is set up correctly if the device switches ON; e. g. If the selected devices operated incorrectly, repeat step 2 to step 6. If a key is not pressed within 30 seconds in the search mode, the remote will stop the search. 5. 6. 7. Note: Identifying CODE numbers ­ from the automatic search: 1. & key Note: If the LED does not blink at all, the corresponding code for the first digit is 0. 2. 4. Count the number of times the LED blinks and record this number. Continue by pressing & and count the number of times the LED blinks then record this number. Continue by pressing & and count the number of times the LED blinks then record this number for the third digit. Key does not blink at all, it means the 1st digit of the code number is [0], key blinking twice means 2nd digit is [2], key blinking 8 times means 3rd digit is [8], therefore the code number is 028. Example: If you think that the searching process is too slow, you can advance the database searching process by pressing button. Your Code Numbers For future reference please record your CODE numbers in the fields for your devices: TV VCR DVD-Player STB 1 STB 2 2 www. strongsat. com GB Basic functions: 1. SET ­ Used for programming other devices, such as VCR/DVD-Player etc. STB1 ­ Default button for Strong SRT 6125/6155/6355 digital satellite receivers. SUB ­ Display subtitles of broadcast in STB1 mode Used for stepping through the channels or navigating within the OSD Menus in STB1 mode. CHANNEL Up/Down ­ Used for stepping through the channels or navigating within the OSD Menus in STB1 mode. VOL Left/Right ­ Used for adjusting the volume or for navigating within the OSD Menus (left / right) in all modes. [. . . ] Buttons 26-29 ­ In Teletext mode: Functions according to Teletext content. 0 - 9 Numeric ­ Direct entry of numerical functions in the menus or in channels selection www. strongsat. com 3 GB Specific functions of the remote control: TV All functions are marked directly on the keys. Stepping through the channels Displays current channel list Enables/disables Teletext and use 4 colour buttons Switches back to previous channel Colour function: increase/ decrease Brightness function: increase/ decrease RED - / GREEN + YELLOW - / BLUE + VCR PLAY function STOP function Record function Forward function Backward function Pause function DVD PLAY function STOP function Forward function Backward function Pause function STB Displays the list of favourite channels Displays subtitle of broadcast Cursor for navigating within the OSD menu Confirm actions in the menu system Switches between TV or Radio mode Setting up the receiver Shows program information. [. . . ]