User manual STRONG SRT ANT 12

[. . . ] This DVB-T Antenna is a "Active type" antenna, it has an build-in low noise amplifier that amplifies the received signals for better performance. We recommend you to carefully read this user manual before you install the antenna, this will help you to get the best performance out of your antenna. [. . . ] Keep the antenna in your hand and try to reach the highest possible position. Now slowly turn the antenna around it's axis (in the horizontal field), at the same time monitor the signal bars in the menu, once the signal indicator shows the maximum signal, fix the antenna on that position. It is important to place the antenna in such way that an acceptable signal level is assured. You can optimise the signal strength by moving the antenna to different locations in your room, for example place it near a window, or place it on a high placed book-shelf. Note - It is recommended NOT to place the antenna near to: n Devices that are strong source of radiation or interference such as DECT and GSM telephones, Transmitters, Microwaves, etc. n Devices with high power consumption such as Electrical Heater, Air conditioner, Hairdryers, etc. Use this installation if your Digital Terrestrial Receiver does not support active antenna. Connect supplied power adaptor to "DC IN" connector on the back of antenna. Proceed with positioning of antenna as described above in section A (points 3, 4, 5). Note: The antenna will not function properly if the build-in amplifier is not powered. Therefore it is required to supply the antenna with power via the coaxial cable or via a external adapter. Extension of the coaxial cable: In some cases you may need to extend the standard supplied coaxial cable, we advise you to only do this if you can not get a optimal signal strength within the reach of the standard cable. If you are to extend the coaxial cable, then please note following comments: n Use a good quality coaxial cable, 75 Ohm type only with proper shielding n Use well shielded connectors, your dealer can advise you on this n Make sure that both inner cable and shielding are properly connected to the connectors to assure active antenna power supply and to avoid short circuit in the cable If you extend the cable, please keep the cable as short as strictly needed. [. . . ] We also recommend disconnection from mains supply when not in use for longer periods of time. Batteries Do not dispose of the batteries from your handset with your domestic waste. [. . . ]