User manual STRONG SRT V50

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual STRONG SRT V50. We hope that this STRONG SRT V50 user guide will be useful to you.


STRONG SRT V50 : Download the complete user guide (1565 Ko)

Manual abstract: user guide STRONG SRT V50

Detailed instructions for use are in the User's Guide.

[. . . ] For Index 0 ~ 999, the lower right dot (1K Indicator) will not light on. For Index 1, 000 ~ 1, 999, the lower right dot (1K Indicator) will light on. 4 PART 1 · English Index 888 Index 1. 888 5. 0 CABLE CONNECTION 1. Connect the Motor to the terminals printed M1 & M2, and connect the Reed Switch Sensor to the terminals printed SENSOR via Motor Cable. [. . . ] To unlock, press Lock key with following Enter button again to unlock the positioner. 7 English PART 1 · English Lock Enter Restore Factory Default (Reset): This function will clear all data in the Positioner, includes High/Low Limits, Satellite Positions, . . . , etc. Press the Power button on the top of the positioner and re-plug to the AC outlet. To stop the Reset process, unplug from the AC outlet before counting to 1. Keep pressing the "Reset" button on the remote control until the positioner finishes counting down from 10 to 1. To stop the Reset process, simply stop pressing the Reset button before the positioner counts down to 1. If reset has been successfully completed, it will show " æ æ æ " on the LED. (count number 1000). After 2 Seconds 7. 0 FOR DISEQC 1. 2 RECEIVER The denomination of some commands might be different, but similar. Set the Software High / Low Limits: After sending the commands from the DiSEqC 1. 2 receiver, the Display of the positioner will show as below: Low Limit High Limit Low Limit North Hemisphere South Hemisphere East Limit West Limit East Limit High Limit West Limit Cancel the Software High / Low Limits: After sending the command from the DiSEqC 1. 2 receiver, the Display of the positioner will show "LoF". Drive the Actuator East / West until the picture on the TV screen is clear. The Display will show "C01~C60" then show "P01~P60". from the receiver, the positioner will drive the actuator to the intended position. However, if the position has not been stored yet, the positioner will ignore the command. Note: If the Channels and Satellites are well preset on the receiver, it will drive the actuator to the right position while user changes the Channels. After arriving the right position, the Display will show the Satellite no. The Display will show "PXX" (for example "P03") for 1 second and then the motor will start moving. After the motor moves, drive the actuator East /West until the picture on the TV for this Satellite is clear for "P03". [. . . ] 10 PART 1 · English Repeat Step 1 to 3 to set up all the satellites you prefer. Manual Buttons English East (West) / Down West (East) / UP Power / Store Recall a Satellite Position: Change the DiSEqC 1. 0 setting of the channels. (No response) Reset the positioner Unplug the AC Power Cord from the AC outlet. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE STRONG SRT V50




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual STRONG SRT V50 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.