User manual TAURUS AP 2040

[. . . ] ) --Do not spray any flammable material such as insecticides or fragrance around the appliance. --This appliance cannot replace normal ventilation, daily dust collection or oil pumping when cooking. --Ensure that appliance is used in condition of a stable and horizontal surface. [. . . ] --The plug must be easily accessible so it can be disconnected in an emergency. --Remove the appliance's protective film and follow figures 1, 2, 3, 4. --To eliminate the smell given off by the appliance when used for the first time, it is recommended to have it on at full power for 2 hours in a well-ventilated room. --Prepare the appliance according to the function you wish to use: uSE: --Extend the cable completely before plugging it in. --Attach the appliance to its base / connector making sure that it is correctly fitted into place. --Attach the appliance to its base making sure that it is correctly fitted into place. --Ensure that the electronic connector is properly attached to the appliance. --Guide the appliance to direct the flow of air in the desired direction. uSE: --Press two times to enter the first fan speed, and the first indicator is on; --Press three times to enter the second speed, and the second indicator is on; --Press four times to enter the third speed operation, and the third indicator is turned on; --Press five times to enter the fourth speed and light the fourth indicator; --Press six times to turn off; cHILD LOCK: --Long press the "Switch button" for 3 seconds to enter the child lock mode, --the child lock indicator light will show blue. --Hold the "Switch button" for 3 seconds again, the child lock indicator light would be off with this function. fILTER BUTTON: --When the filter life expires (about 2500hr), the filter replacement indicator will flash to remind you, it is high time to change the filter. --After changing the filter, hold the "Filter button" down for 5 seconds to reset sLEEP BUTTON: --In the state of power-on, press the "Sleep button" briefly, the purifier enters the sleep mode, and all the lights except the sleep status indicator are off. If any key is pressed, the display will resume for 30 seconds, and then press any key again within 30 seconds to exit sleep and enter the automatic mode. cLEANING --Disconnect the appliance from the mains and allow it to cool before undertaking any cleaning task. --Clean the electrical equipment and the mains connection with a damp cloth and dry. --Clean the equipment with a damp cloth with a few drops of washing-up liquid and then dry. [. . . ] Verificai piesele mobile pentru a vedea dac sunt nealiniate sau blocate i asigurai-v c nu exist piese rupte sau anomalii care pot afecta funcionarea corect a aparatului. WARRANTY AND TECHNICAL ASSISTANCE This product enjoys the recognition and protection of the legal guarantee in accordance with current legislation. To enforce your rights or interests you must go to any of our official technical assistance services. [. . . ]