User manual TEAC AR630 MKII

[. . . ] < Caution should be taken when using earphones or headphones with the product because excessive sound pressure (volume) from earphones or head-phones can cause hearing loss. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or groundingtype plug. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] < Make sure the wire is fastened firmly by pulling the cable lightly. D AC Outlet (switched) This outlet is active only when the unit is on. Caution: Make sure that the total power consumption of all equipment connected to the outlet does not exceed 500mA or 100 watts. F AC power cord After all other connections are complete, connect the power cord to the AC wall socket. < Be sure to connect the power cord to an AC outlet which supplies the correct voltage. < Hold the power plug when plugging in or unplugging the power cord. 5 Identifying the Parts A B C D E D F G O N M L K J I H a b D G F 6 A Remote Sensor When operating the remote control unit, point it towards the REMOTE SENSOR. STANDBY/ON When the power switch of the main unit is depressed, use this button to turn the unit on or standby. INPUT SELECTOR Use this knob (or buttons of the remote control unit) to select a source. TAPE 2 MONITOR When a cassette tape deck is connected to the TAPE 2 jacks, use this button to turn on or off the tape monitor function. VOLUME Turn this knob (or press the VOLUME buttons of the remote control unit) to adjust the volume. MIC Jack and MIC LEVEL knob With the microphone plugged into this jack, the sound picked up from the microphone will be heard together with the source sound selected by the INPUT SELECTOR. LOUDNESS Use this button to compensate for the loss of bass at low volumes. SOURCE DIRECT Press this button to turn on or off the source direct function. When the source direct function is set to on, the button lights and you can listen to the sound without tone effects. TREBLE Use this knob to adjust the level of high frequency information. N SPEAKERS buttons Use these buttons to turn on or off the speakers. PHONES jack For private listening, insert the headphones plug into this jack, and adjust the volume by turning the VOLUME knob. B O C Remote Control Unit When operating the CD Player (CD-P650) or the tuner (T-R650/ T-R650DAB) using the remote control unit, select a source first using INPUT SELECTOR buttons (boxed D ) on the remote control unit. A ON When the POWER switch of the main unit is depressed, use this button to turn the unit on. D ENGLISH E F b STANDBY When the POWER switch of the main unit is depressed, use this button to turn the unit standby. Other buttons are used for operation of TEAC's CD-P650, T-R650 and T-R650DAB. [. . . ] For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC. By disposing of these products and batteries correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. For more information about collection and recycling of old products and batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items. Information on Disposal in other Countries outside the European Union These symbols are only valid in the European Union. [. . . ]