User manual TECHNICS SL-P990

[. . . ] (Only for U. S. A. ) To order accessories contact 1-800-332-5368 or the website (http://www. panasonic. com). (SFPWG17201BK) Table of contents Supplied accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ¡Reorient or relocate the receiving antenna. ¡Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ¡Consult the dealer or an experienced radio/TV technician for help. Any unauthorized changes or modifications to this equipment would void the user's authority to operate this device. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 3 RQT7021 Features A masterpiece amongst turntables with a worldwide reputation. Highly accurate turntable speed maintained continuously with a quartz pitch control. ·The [±16/±8] button can control a wide range between ­8 % and +8 % and ­16 % and +16 %. ·The pitch can be varied throughout the range maintaining perfect accuracy. ·Pitch can be instantly reset to the rated speed (33 1/3 or 45 r/min) with the reset button. ·The pitch control slider can be easily replaced. Controls The direct drive produces high torque. ·Wow and flutter below 0. 01 %. Starting torque of 1. 5 kg-cm enabling the turntable to reach 33 1/3 r/min in 0. 7 seconds. ·Smooth stops are achieved with a fully electronic braking system. Turn the stylus pressure control dial to the setting you previously used to balance the weight including cartridge. Tone arm height 1. Adjust the arm height. ·Adjust the ring using the chart below as reference so the arm height matches the indicated height of the cartridge. Measurements are marked on the arm height control ring in 0. 5 millimeter intervals. Balance weight measurement units Index line Arm height control ring Cartridge height (H) in millimeters Height control position 0 1 2 3 4 5 6 Anti-skating Adjust the dial to the same value as the stylus pressure control when playing normal music. For scratch play Adjust the control to reduce skipping. 17 18 19 20 21 22 23 ·If you do not know the height of your cartridge, rest the stylus on a record and adjust the height control until the tone arm and record are parallel. Lock the arm after adjusting the height. Fit the dust cover Hold the dust cover with both hands and fit it over the player from directly above. Use a screwdriver to turn the armlift screw. Make this adjustment only if the cartridge you are using makes it necessary. ·Turning the screw anti-clockwise raises the armlift. Armlift screw Armlift Armlift height (the distance between the record and stylus when the cue lever is raised) is set to between 8 and 13 millimeters at time of shipment. 7 RQT7021 Playing records Preparation 1. Take off the stylus cover and release the arm clamp. 1 Turn [power] to turn the unit on. ·The pilot lamp comes on. ·33 1/3 r/min is automatically selected and the indicator lights. ·Press [45] if you are playing a 45 r/min record. off 1 3 2 Pilot lamp Indicator lights 33 45 on p o we r Press [start-stop]. The turntable starts revolving. start · stop 33 2 4, 5 3 Press [reset] to light the pitch control green LED lamp. The pitch returns to 33 1/3 or 45 r/min. Use the above indicated pitch for playing standard music. Green LED indicator reset 4 To temporarily stop play Lift the cue lever. The stylus lifts off the record. Lift the cue lever and move the tone arm over the record. Refer to page 9 for fine adjustments to the pitch When using EP records EP record adaptor 1. Take the EP record adaptor out of its holder and fit it over the center spindle. [. . . ] Servicing--Do not attempt to service the unit beyond that described in these operating instructions. Replacement parts--When parts need replacing ensure the servicer uses parts specified by the manufacturer or parts that have the same characteristics as the original parts. Unauthorized substitutes may result in fire, electric shock, or other hazards. Safety check--After repairs or service, ask the servicer to perform safety checks to confirm that the unit is in proper working condition. Thoroughly clean dust off the stylus and record. ·Use a soft brush to clean the stylus. [. . . ]