User manual TEFAL CB7031 11-05

[. . . ] READ AND SAVE THESE INSTRUCTIONS This appliance is designed to vent cooking smoke and odors only. Be certain your appliance is properly installed and grounded by a qualified technician. To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. If there is any doubt, have the electrical system of the house checked by a qualified electrician. [. . . ] To help prevent resoiling, a conditioner for stainless steel can be applied. Grease filter The reusable metal grease filters remove solid particles from the vented kitchen air like grease and dust, etc. An internal filter is situated above the external filter within the casing. The grease filters should be cleaned every 3-4 weeks or whenever the grease filter indicator lights. Dirty filters are a fire hazard. Cleaning the casing Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. ^ All external surfaces and controls can be cleaned with warm water and liquid dish soap applied with a soft sponge. For recirculation mode an active charcoal filter must be used in addition to the grease filters. The active charcoal filter is inserted into the slot on the front of the appliance. Dispose of the charcoal filter with the household waste. 16 Cleaning and care Changing the light bulbs If the light does not work the bulb may need to be replaced or the starter could be defective. ^ Remove the external filter as described in "Removing the filters". ^ Return the external filter. ^ Unscrew the fixing screws on the right and left hand sides of the light cover. While undoing the screws hold the cover securely so that it does not drop on to the cooktop below. 17 After Sales Service In the event of a fault which you can not correct yourself please contact the Miele Technical Service Department U V 1-800-999-1360 techserv@mieleusa. com 1-800-565-6435 service@miele. ca When contacting the Technical Service Department, please quote the model and serial number of your appliance. Reducing collar Air extraction The appliance is designed for 6" (150 mm) diameter ducting. If a 5" (125 mm) diameter is required: ^ Insert the non-return flap into the vent socket so the flaps open upward. (This is not necessary if the ducting system is already fitted with a non return flap, e. g. Recirculation mode When used in recirculation mode a non-return flap it is not necessary. ^ Place the supplied reducing collar on the vent socket (see "Connection for air extraction"). Recirculation mode ^ Place the reducing collar for a 5" (125 mm) diameter on the vent socket as previously described. 28 Installation 3. Runners The measure "x" will depend on the type of lightshield used. The Miele DFB lightshield (optional accessory) sits flush with the cabinet front. ^ Cabinet width 60 cm: Install the runners on the left and right side of the cabinet with (4) 3. 5 x 16 mm screws on each side. If the side panels are 5/8" (16 mm) thick, use the bracket side with the marker "16 mm". If the side panels are 3/4" (19 mm) thick, turn the bracket and use the side with the marker "19 mm". The runner's adjustable range allows the hood position to be adjusted by ± 9/16" (15 mm). Hood installed with a cabinet matching light shield (custom made) Note: Please refer to the "Special installation instructions" at the end of this section for instructions on installing the appliance into a 27 9/16" (70 cm) or 35 7/16" (90 cm) wide cabinet. 29 Installation 4. [. . . ] When installing the ventilation grill make sure that the slats in the grill point towards the center of the room and not towards a wall or the ceiling. ^ The vent connection (vent socket) a and the exhaust grill b must be joined together with a pipe or flexible duct c cut to size. 14. Electrical connection Refer to the notes in "Electrical connection" and "Important Safety Instructions" before connecting to electricity. ^ Plug in the power cord. 36 Installation Special installation instructions 27 9/16" (70 cm) width cabinet 35 7/16" (90 cm) width cabinet ^ The measure "x" will be calculated as described for a 23 5/8" (60 cm) cabinet. [. . . ]