User manual TEFAL CM2105

[. . . ] · If you reduce the thermostat, wait for the lamp to come on again before continuing with your ironing. · If you are ironing a mixed-fibre fabric: set the ironing temperature according to the most fragile of the fibres. Steam production is automatically adapted to the temperature selected. Caution · Your iron only produces steam when the thermostat control is in the coloured zone. 3 - ANTI-DRIP FUNCTION · When the iron's temperature is no longer sufficient to produce steam, the water supply is automatically cut off so that the soleplate does not "drip". [. . . ] · When you first use it, you must wait for 2 minutes before steam becomes available. Caution · Always put the iron back on its base for maximum ironing efficiency. Tip · Use this ironing mode for small items and fabrics that are easy to iron. Tip · Use this ironing mode for large items and fabrics that are difficult to iron or when you use the SuperPress button frequently. To smooth vertically · Hang up the garment and stretch the fabric. Set the thermostat control to MAX, press the SuperPress button (x) repeatedly and move the iron from the top downwards. Tip: · If you have to use the SuperPress button very frequently, use the iron with the Cord setting. · Hold the iron a few centimetres from the fabric to avoid burning delicate fabrics. To remove resistant creases · Press the Spray button repeatedly to wet the linen or use the SuperPress button. 5 - MAINTAINING YOUR IRON Caution Always unplug and leave your iron to cool before cleaning it. When you first use it, you must wait for 2 minutes before steam becomes available. SOLUTIONS PROBLEMS AND POSSIBLE CAUSES · Fabric fibres have built up and become charred in the soleplate holes or between the iron's casing and the soleplate. · Your ironing is not rinsed sufficiently or you are using starch. · You have placed your iron face down on a metal iron rest. SOLUTIONS Clean the soleplate with a damp non-metal pad. Spray the starch on the underside of the surface to be ironed. Always place your iron on its base. 8 - FOR YOUR SAFETY · Caution!the voltage of your electrical installation must match that of your iron (220-240V). Incorrect connection may cause irreparable damage to the iron and render the guarantee null and void. If your are using an extension lead, ensure that it is the bipolar type (13 A) with an earth conductor. · If the power cord is damaged, it must be replaced immediately by an Approved Service Centre to avoid danger. · The base and the connection block must only be used with the iron that accompanies them. [. . . ] · If the power cord is damaged, it must be replaced immediately by an Approved Service Centre to avoid danger. · The base and the connection block must only be used with the iron that accompanies them. · Set the iron to Cordless and always remove it from its base before filling or emptying the tank. · If the iron is dropped, have it examined by a professional before turning it back on: invisible damage may cause a safety hazard. [. . . ]