User manual TEFAL EASYSTORE TURBO

[. . . ] · When starting, and regularly while it is being used, your steam generator's electric pump injects water into the boiler. You may also hear a clicking noise which is the steam valve opening. Again this is normal. If you are pressing on the steam control button at this time you may lose a little steam pressure momentarily. 5- OPERATING THE CONTROL PANEL · Flashing green light : the water is heating up in the boiler. · Orange "boiler rinse" light flashes : your boiler needs rinsing. Recommendations : 8- VERTICAL STEAM IRONING 1. [. . . ] It is recommended that you start with fabrics to be ironed at a low temperature: synthetics (). For delicate fabrics (), press the steam control button (under the handle of the iron) intermittently to avoid possible water droplets appearing with the steam. (12) (11) 11. THE ORANGE "BOILER RINSE" LIGHT FLASHES Note: · To extend the efficient operating life of your boiler and avoid scale particles on your linen, your generator is equipped with an orange "boiler rinse" warning light that flashes on the control panel after about 10 uses. · Do not use descaling agents for rinsing out the boiler, as they could damage it. 12- PUTTING YOUR STEAM GENERATOR AWAY 1. Raise the retaining hoop over the iron until it locks into place (audible click) (21). Your iron is then safely retained on its base. On the model with an automatic reel, press the reel button and guide the cord with your free hand. 6. You can then put your steam generator away carrying it by the iron handle (23). II. TO RINSE THE BOILER WITHOUT THE RINSING ACCESSORY Before attempting to rinse the boiler of your generator, it is essential to leave it to cool for at least 2 hours in order to avoid any risk of scalding. If the orange "boiler rinse" light flashes, you can continue ironing normally but remember to rinse the boiler first, the next time that you use it. Place your steam generator on the edge of your sink, with the iron to one side, standing on its heel. Holding your steam generator in a tilted position, and using a jug, fill the boiler (in the base unit) with 1/4 litre of tap water. Shake the base unit for a few moments and then empty it completely over your sink. To obtain the best result, we recommend that this operation is done twice. TO RINSE THE BOILER USING THE RINSING ACCESSORY For greater effectiveness and for ease of operation, you are advised to use the rinsing accessory provided in the box. It will make it easier to rinse the boiler as the generator will need less handling. CLICK (a) 1 (21) (22) (23) 2 the "restart" button for 2 to 3 seconds to turn off the orange light. Your rinsing accessory has been designed to work on a wide range of taps. If you do not wish to, or cannot use the rinsing accessory, refer to the advice in paragraph II (next page). Before attempting to rinse the boiler of your generator, it is essential to leave it to cool for at least 2 hours in order to avoid any risk of scalding. If the orange "boiler rinse" light flashes, you can continue ironing normally but remember to rinse the boiler first, the next time that you use it. Place your steam generator on the edge of your sink, with the iron to one side, standing on its heel. Place the plastic nozzle 1 of the rinsing pipe into the hole of the boiler and turn gently to the right until it locks. Turn the tap on gently and gradually and let cold water run through the rinsing pipe into the sink for about 1 minute (20). [. . . ] · Press the « Restart » button on the control panel. · The soleplate is dirty or brown and may stain the linen. · You are ironing at too high a temperature. · You are using starch. · There is little or no steam. · The removable water tank is empty (red "water tank empty" light on). · You have not pressed the "Restart" button. · You have filled the tank but there is no steam. · Steam escapes from the rinse plug. · The rinse plug has not been tightened correctly. [. . . ]